HighGear Enduro mini Manuel de l'utilisateur - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} HighGear Enduro mini. HighGear Enduro mini 17 pages. Techtrail running wristware

Imprimer la page

1. Resetting the Watch

REPLACING THE WATCH BATTERY

The Enduro watches use a common CR1632 3v Lithium battery. Normal battery life is

approximately 1yr.

NOTE: Heavy usage of the Backlight system may significantly reduce battery

life.

NOTE: A blank display or inaccurate readings are indications that the battery is

getting weak and should be replaced.

Remove battery door using a coin.

Carefully remove the old battery. Do not damage the O-ring

seal.

Place a fresh battery in the battery compartment with the

positive (+) side facing up.

Replace battery door using a coin.

If the O-ring has been damaged, replace it before reinstalling

the battery door. Most jewelers and watch shops should have

replacement O-ring seals.

NOTE: Extreme care should be taken when replacing the battery to ensure the

unit remains fully water resistant. Failure to properly replace the battery and

correctly seal the unit may cause the unit to become damaged and may void the

warranty

RESETTING THE WATCH

To reset the watch back to its default values

SET/CLEAR,

START/LAP

and

STOP/NEXT

same time. The display will light up showing all segments

followed by a sequence of screens showing various numbers.

The watch will then automatically change to the time of day

screen at 12 o'clock on the first of January.

Resetting the watch will clear any information stored in the

watch. This should be done only as a last resort.

PRESS

the MODE,

keys down at the