Gallagher C300431 Note d'installation - Page 5

Parcourez en ligne ou téléchargez le pdf Note d'installation pour {nom_de_la_catégorie} Gallagher C300431. Gallagher C300431 13 pages.

Before you begin

2.1

Shipment contents

Check the shipment contains the following items:

•

1 x Gallagher T11 Reader facia assembly

•

1 x Gallagher T11 Reader bezel

•

1 x M3 Torx Post Security screw

•

2 x 6-32 UNC Phillips drive fixing screws

•

4 x 25 mm No.6 self tapping, pan head, Phillips drive fixing screws

•

4 x 40 mm No.6 self tapping, pan head, Phillips drive fixing screws

2.2 Power supply

The Gallagher T11 Reader is designed to operate over a supply voltage range of 9 - 16 Vdc

measured at the reader terminals. The operating current draw is dependant on the supply

voltage at the reader. For the Mifare reader, at 13.6 Vdc the current draw is 84 mA (idle). During

card read, beeper and LED activity, the current will momentarily reach 113 mA (maximum). For

the Multi Tech reader, at 13.6 Vdc the current draw is 100 mA (idle) and will momentarily reach

124 mA (maximum). The power source should be linear or a good quality switched-mode power

supply. The performance of the reader may be affected by a low quality, noisy power supply.

2.3 Cabling

The Gallagher T11 Reader requires a minimum cable size of 4 core 24 AWG (0.2 mm

security cable. This cable allows the transmission of data (2 wires) and power (2 wires). When

using a single cable to carry both power supply and data, both the power supply voltage drop

and data requirements must be considered. Although the reader is specified to operate at 9

Vdc, for good engineering design it is recommended that the voltage at the reader should be

approximately 12 Vdc.

HBUS cabling topology

The HBUS communications protocol is based on the RS485 standard and allows the reader to

communicate over a distance of up to 500 m (1640 ft).

The cabling between HBUS devices should be done in a "daisy chain" topology, (i.e. A "T" or

"Star" topology should not be used between devices). Should "Star" or "Home-Run" wiring be

required, the HBUS 4H/8H Modules and the HBUS Door Module allow multiple HBUS devices to

be individually wired to the one physical location.

The end devices on the HBUS cable should be terminated using 120 ohms resistance. To

terminate the Gallagher Controller 6000, connect the supplied on-board termination jumpers

to the Controller. To terminate a reader, connect the orange (termination) wire to the green

(HBUS A) wire. Termination is already included at the HBUS Module, (i.e. each HBUS port is

permanently terminated at the module).

3E4289 Gallagher T11 Reader | Edition 1 | August 2016

) stranded

Page 5