COPERTINA inglese 0612 Instructions et avertissements - Page 10
Parcourez en ligne ou téléchargez le pdf Instructions et avertissements pour {nom_de_la_catégorie} COPERTINA inglese 0612. COPERTINA inglese 0612 15 pages. Automatic modular ice-cube maker
Imprimer la pageThis appliance contains fluorinated greenhouse gases covered by the Kyoto Protocol.
‼
The Manufacturer shall not be liable for any damage to the environment, animals, persons
or objects caused by incorrect installation.
The voltage and frequency are given on the data plate on the appliance. Refer to this data plate to
check compliance.
Voltage (1), power (2), model (3), serial No. (4), Manufacturer (5).
The weighted equivalent continuous sound level A of this appliance is less than 70 dB (A). The
measurements were made over an entire production cycle, at a distance of 1 m from the surface of the
appliance and at a height of 1.60 m from the floor.
The wiring diagram is stuck on the rear panel of the appliance.
The net weight and the weight including packaging of the appliance are given on the cover of this
instruction manual. Please refer to the instructions on the packaging in order to correctly transport and
lift the appliance.
To prevent the oil in the compressor from flowing back into the coolant circuit, always make sure that
the appliance is kept upright during transport, storage, and handling. Follow the instructions given on
the packaging.
The appliance must be installed by authorized personnel, in compliance with the current laws in
force and the Manufacturer's instructions.
Once you have removed the packaging according to the instructions on the box, MAKE SURE THAT
THE APPLIANCE IS IN A PERFECTLY GOOD CONDITION. IF IN DOUBT, DO NOT USE IT AND
IMMEDIATELY CONTACT THE DEALER who sold it to you.
All the packaging items (plastic bags, cardboard, polystyrene foam, nails, etc.) must be removed
and put out of the reach of children, as they are potential sources of danger.
Rest the wooden pallet on the floor, unscrew the bolts (if any) anchoring the appliance to the pallet
(Fig. 2), lift the appliance using equipment fit to bear its weight, and separate it from the pallet.
NOTE FOR INSTALLER:
This operation must only be performed by professionally qualified and authorized personnel.
The appliances contain threaded holes for hooking eyebolts (Fig. 3).
To prevent damage to the appliance, the lifting bolts should be kept vertical during lifting.
5.1 CONNECTION DIAGRAM (Fig. 4)
6. electrical connection controlled by omnipolar circuit-breaker with residual current device
7. water tap(s)
8. water supply pipe for ice making
9. water supply pipe for water cooling (W)
10.water drainage pipe(s)
11. cooling water drainage pipe (W - 300 kg/24h production model only)
2 TECHNICAL DATA (Fig. 1)