Dynaudio Sub 6 Manuel du propriétaire - Page 12
Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Dynaudio Sub 6. Dynaudio Sub 6 20 pages.
Imprimer la page
Sub 6 Mains and Signal Connections
The Sub 6 is fitted on its rear face with
3. Balanced XLR output sockets (left
a connection and control panel carrying
and right). The XLR output sockets
mains, signal and connection sockets. The
are intended for the connection of
panel is illustrated in Diagram 3 and its
active left and right main speakers,
connection facilities are described in the
a power amplifier driving the main
following paragraphs. Diagrams illustration
speakers, or a second subwoofer.
various signal connection schemes can also
be found on the following pages.
Note
1. Mains power socket. Connect the
The Sub 6 distance
subwoofer to a mains power supply
compensation signal
using the cable supplied. If multiple
processing can only function
cables are supplied with your
correctly if the main speakers
subwoofer, use the one appropriate
are driven via the subwoofer
for your territory.
outputs.
Note
4. Unbalanced phono input sockets
Do not switch on your
(left and right). If your audio source
subwoofer until all other
provides unbalanced phono outputs
connections have been made.
connect them to these sockets using
high quality phono audio cables.
2. Balanced XLR input sockets
(left and right). If your audio source
Note
provides balanced outputs connect
If your audio source provides
them to these sockets using high
only a mono subwoofer
quality balanced XLR audio cables.
output it can be connected to
either Sub 6 phono input. In
this case however the main
Note
speakers must be driven from
Balanced signal connection
the audio source and not via
is a feature of professional
the Sub 6 outputs.
audio and of some high-end
domestic audio equipment. It
is inherently more resistant to
interference and noise than
unbalanced connection.
22
5. Unbalanced phono output
sockets (left and right). The phono
output sockets are intended for the
connection of active left and right
main speakers, a power amplifier
driving the main speakers, or a
second subwoofer.
Note
The Sub 6 distance
compensation signal
processing can only function
correctly if the main speakers
are driven via the subwoofer
outputs.
6. Trigger input. The trigger input
enables wired remote control of
subwoofer standby and operational
modes in automated home systems.
Your Dynaudio retailer or installer will
be able to provide more information
on the use of the Sub 6 in home
automation systems.
Note
The USB socket present on
the Sub 6 connection panel is
intended for fault diagnosis and
firmware update only. It cannot
be used for audio connection
or playback. Contact your
Dynaudio retailer or Dynaudio
directly for more information of
firmware updates.
Sub 6 Connection Sockets
Service
Auto
ON/OFF
Trigger
Right
Right
Left
in
out
in
out
6
Max. 12 V DC
5
4
5
Right
in
2
3
1
Right
out
100-120 V~, 200-240 V~
50/60 Hz 490 W
Installation
Left
in
4
Left
in
Left
out
23