Dynaudio 9S Manuel du propriétaire - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Dynaudio 9S. Dynaudio 9S 18 pages. Precision bass, optimised for the studio

Imprimer la page
Dynaudio 9S Manuel du propriétaire
POWER
GAIN
PHASE
ON
AUTO
0° 180°
Min
Max
SAT Highpass
SUB Lowpass
Flat
60Hz
80Hz
50 Hz
150 Hz
SAT/SUB Input
SAT Output
LEFT
1.
Stereo
RIGHT
LFE / Slave IN
OUT
1.
LFE
SUB I/O
2.
Mode
LFE
Slave
Multiple subwoofer connections
The 9S can be used stand-alone or
3.
From the Slave output of the first
together with multiple subwoofer units.
subwoofer connect a XLR cable to
Using multiple units may be helpful if the
the LFE/Slave input of the following
listening room is quite large or has difficult
subwoofer. This one now becomes
acoustic conditions. When using two or
the slave.
more subwoofers, the first one (designated
4.
Set the Mode switch of the second
"Master") controls the following subs
subwoofer to Slave.
(designated "Slave") via a subwoofer cable.
Further subwoofers can be connected
To connect multiple subwoofers:
in the same way. Set the Mode switch
1.
Connect the first subwoofer as
of all following subwoofers to Slave
described before.
respectively.
2.
Set Mode switch of first subwoofer
to LFE.
16
POWER
GAIN
PHASE
ON
AUTO
0° 180°
Min
Max
SAT Highpass
SUB Lowpass
Flat
60Hz
80Hz
50Hz
150Hz
SAT/SUB Input
SAT Output
LEFT
RIGHT
LFE / Slave IN
OUT
To Slave
SUB I/O
To Slave
3.
LFE
Slave
Notes
•
When using multiple
subwoofers in a Master-Slave
setup, it is recommended that
the subwoofers are all the
same model.
•
If you wish to use multiple
subwoofers with full individual
control, set the Input switch for
all to the LFE position. From the
source subwoofer output, use a
Y-connector.
Sub (Slave)
4.
Mode
Connecting loudspeakers
If your source bass management, you
can use the 9S's LFE input alone in
LFE or SLAVE mode, depending on the
management system capabilities. Avoid
double processing if possible.
To connect loudspeakers
1.
Connect the subwoofer (see
"Connecting a single subwoofer" on
page 15.
2.
From the subwoofer SAT/SUB output
connect a XLR cable to the inputs of
the power amplifier you use for your
speakers.
POWER
GAIN
PHASE
ON
AUTO
0° 180°
Min
Max
SAT Highpass
SUB Lowpass
Flat
60Hz
80Hz
50Hz
150Hz
SAT/SUB Input
SAT Output
LEFT
1.
Stereo
RIGHT
LFE / Slave IN
OUT
1.
LFE
SUB I/O
LFE
Slave
To power amplifier or active speakers
Note
The signals connected to the inputs are provided at the Slave output for
connecting another subwoofer. See page 16 to learn more about connecting
multiple subwoofers.
2.
To Slave
17