HighPoint RocketRAID 2680 Manuel d'installation - Page 8
Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} HighPoint RocketRAID 2680. HighPoint RocketRAID 2680 8 pages. Sas controller
Imprimer la page
Rocket RAID 2680 FreeBSD Installation Guide
system start up.
Step 4 Configure System to Mount Volumes when Startup
Now you can inform the system to automatically mount the array by modifying the file
/etc/fstab. E.g. You can add the following line to tell the system to mount /dev/da1s1e to
location /mnt/hpt after startup:
/dev/da1s1e
4 Updating the Driver
To update the driver with a new version you simply reinstall the driver following the previous
section, "Install the driver on an existing system".
5 Installing RAID Management Software
HighPoint RAID Management Software is used to configure and keep track of your hard
disks and RAID arrays attached to RR2680 controller. Installation of the management
software is optional but recommended.
To configure HighPoint RAID Management Software to work with RR2680 driver, you
should setup /etc/hptcfg to be the driver name:
# echo rr2680 > /etc/hptcfg
Please refer to HighPoint RAID Management Software documents for more information.
6 Uninstalling
You can only uninstall the driver when your system is not booting from devices attached to
RR2680 controller. Just remove the line
rr2680_load="YES"
in /boot/defaults/loader.conf, and then delete the driver module /modules/rr2680.ko or
/boot/kernel/rr2680.ko .
/mnt/hpt
ufs
rw
0
0
- 6 -