HighPoint Thunderbolt TurboBox NA211TB Manuel d'installation rapide - Page 3
Parcourez en ligne ou téléchargez le pdf Manuel d'installation rapide pour {nom_de_la_catégorie} HighPoint Thunderbolt TurboBox NA211TB. HighPoint Thunderbolt TurboBox NA211TB 3 pages. Expansion enclosure
Imprimer la page
Thunderbolt
4. Put the top cover back and tighten the thumbscrew.
Step 4
6.
Fan Speed Adjustment
To adjust the fan speed of 80 mm cooler on NA211TB, pull
the fan cooler out. On the top side of cooler's connector,
there are five sets of jumpers labeled 4, 3, 2, 1, and F from
top to bottom. The default setting is the jumper being placed
over pin 5 and pin 6 on label 2 for moderate fan speed.
The fan speed increases from label 4 to label F
(F is full speed). If all pins are open (no jumper placed over
pins), the fan will not spin.
9
7
5
3
1
7.
Operation and Verification
The following verification steps are for Mac OS only.
When verification steps for Windows operating system
become ready, the content will be added.
1. Connect TurboBox with power source, and then connect
TurboBox and HOST with Thunderbolt
Thunderbolt cable
TM
PCIe Expansion Enclosure
2. The NA211TB is designed to be powered on and
powered off simultaneously with HOST when TurboBox
NA211TB is connected to HOST by Thunderbolt
Therefore, power on HOST first, and then NA211TB will
be powered on automatically. (NA211TB supports hot-plug
and hot-unplug for powering-on and powering-off)
3. Verify HighPoint Thunderbolt
HOST. Click the Apple icon on top left of the screen, and
select About This Mac, and then select More Info. Next,
select System Report, and select Thunderbolt
of the pane of System Information. Select NA211TB to see
information about HighPoint Thunderbolt
10
8
6
4
2
TM
cable.
iMac
TM
cable.
TM
target card is recognized by
TM
on left side
TM
target card.
Step 3.1
Step 3.2
Step 3.3
Step 3.4
4. Verify the PCIe cards installed inside NA211TB.
After seeing information on HighPoint Thunderbolt
card, click PCI Cards on left side of the pane of
System Information, and then you will see all the PCIe cards
listed. (For RAID controller card, from starting up, it will take
more time for its info to be shown)
5. Verify the drivers of PCIe cards are installed.
When you see all the PCIe cards listed on step 4,
there will be a column Driver Installed indicating the
status of the drivers of the PCIe cards.
If the status shows "No", please find and install the
TM
-aware driver of the PCIe card, and
Thunderbolt
then the status will show "Yes".
6. While TurboBox NA211TB is connected to HOST by
Thunderbolt cable, when shutting down the HOST,
the NA211TB will be shut down simultaneously as well.
If you have any further questions, please contact your
regional distributor, or HighPoint Technologies,Inc
HighPoint Technologies, Inc.
Address: 1161 Cadillac Court, Milpitas, CA 95035
E-mail:
Phone:
(408) 240-6108 (Monday~ Friday, from 9am~6pm)
Skype:
Highpoint.Thunderbolt
Support: www.highpoint-tech.com/websupport
TM
target