HighPoint RocketStor 5315 Manuel d'installation rapide - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel d'installation rapide pour {nom_de_la_catégorie} HighPoint RocketStor 5315. HighPoint RocketStor 5315 8 pages. Industry's first 6gb/s port multiplier storage dock

Imprimer la page

Power Button

Configuring and Using the RocketStor 5315

Using the RocketStor 5315 by step

1. To install a drive: Carefully align the SATA device's gold fingers with the bay's

SATA connector. Gently push the device straight down until secure.

2. Connect the RocketStor to the RR600 series HBA using an eSATA cable.

3. Connect the power adapter to the DC-In port (back of the RocketStor).

4. Press the power button on the rear of the RocketStor 5315. The bottom

panel of the storage dock will emit blue light when fully powered on.

5. Each SATA bay LED will glow blue when a drive is installed and powered on.

6. The temperature and SMART attributes of each drive are displayed under

"SHI" of the HighPoint RAID Management interface (WebGUI).

7. Before removing a drive, first use the "unplug" function of the

Management interface, then power off the drive using the corresponding

Power/LED button.

Note: The surface temperature of some 3.5" hard disks may exceed 50

degrees C after extended use - approach with caution. Carefully assess the

surface temperature of any hard disk before removal. If you suspect the

temperature is too high, please power down the target drive using the

bay's independent power button. Allow the drive to cool for several

minutes before removal.

The RocketStor 5315's main power button. Press to

power on the unit. Press and hold to power it off (the

blue LED will turn off when the unit is fully powered

down).