Galley-Mate 6001 Manuel d'installation et d'utilisation - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel d'installation et d'utilisation pour {nom_de_la_catégorie} Galley-Mate 6001. Galley-Mate 6001 10 pages. Reverse osmosis high purity water production system

Imprimer la page

STARTING YOUR INSTALLATION

PREPARATION

Check the following list of components to ensure that

all parts are packed with your system. Note, installation

requirements will vary from vessel to vessel. Often we

find the location for the installation is under the galley

sink, nevertheless, many systems are installed in re-

mote locations such as the engine room, at which point

added materials may be required. Your distributor will

be able to supply additional fittings, tanks and longer

tubing runs if your installation were to require those.

1– Water Storage Tank (Remote Tanks boxed

separately if required for your installation)

1– Reverse Osmosis Purification assembly

1– Box with Pre & Post Filters plus Membrane element

1– Installation Kit with assorted fittings and tubing

(5ft)

All tubing is individually labeled and color coded for ease of your installation.

1/4" Red – Connects the feed water line valve to the RO Pre-Filter

3/8" Blue – Connects the RO Membrane Product Port to the Storage Tank(s)*

1/4" Red – Connects the Membrane Reject Port to the Drain Connector**

3/8" White – Connects the Post Filter to the Faucet***

For Remote Tanks to Bridge or Wet Bars, order special FDA approved tubing from our Distributor

On certain installations, depending on water source and tank size, reject may be returned to fresh tank ,

to an existing drain or to a thru the hull fitting.

***

On Remote Tank installs, a 3/8" Quick Connect "T" can be located on blue line (3/8") interconnecting the

tanks. Kit includes an in-line shut off. An Optional in-line polishing filter at the remote faucet connection

is available to pick up any possible taste from long tubing runs.

Fittings and Tubing

John Guest

fittings are used throughout the system.

™

To insure optimal seal, tubing should be cut with the

end perfectly square. An angled cut or distortion of the

tubing will not provide an efficient seal and may cause

leaks.

To install a tube, push it through the collet until it seats

firmly. To remove a tube, push in the collet towards

fitting, and pull out the tube.

Determine the location for the installation of the RO

system. Avoid locations where the system might come

in contact with hot surfaces such as engines, exhaust,

hot water pipes, electrical panels and other hazards.

Determine the location for the pure water faucet. Check

to see that drilling a hole in a galley counter or sink

will not damage pipes or wires running under the sink.

If a second faucet is being installed in a remote sink or

entertainment bar area, and there is no cabinet under

sink, verify that there is a removable access panel.

Determine location(s) of storage tank(s). A maximum

of 15 feet is possible for close installations from tank to

faucet(s). If added faucets are being used, you will need

to add additional storage tanks at those locations.