Frigidaire 300 series Manuel d'utilisation et d'entretien - Page 10

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'entretien pour {nom_de_la_catégorie} Frigidaire 300 series. Frigidaire 300 series 16 pages. Electrolux

Imprimer la page

Care and Cleaning

Burn Hazard

Allow heating element to cool

before cleaning the interior.

Failure to do so can result in

burns.

Outside--Occasionally

wipe with a mild

nonabrasive

detergent

and water. Rinse and

dry.

Models with Stainless

Steel Door--

Clean stainless

steel door with Stainless

Steel

Magic, trademark

of Magic American

Corp., or

similar product using a clean, soft cloth. Avoid

harsh or gritty cleaners or scouring pads which

may scratch the finish.

Inside--The

inside of the dishwasher

is self-

cleaning with normal use. If needed, clean

around the tub

gasket area with a

damp cloth.

The filter is self-

cleaning.

A glass

trap located in the

center of the filter is

designed

to collect

pieces of broken

glass, straws, bones

and pits. To remove

items in glass trap, grasp handle, lift out, empty

and replace.

Note: Hard water may cause lime deposit

buildup on the interior of the dishwasher.

For

cleaning

instructions

see "Removing

Spots

and Film" section.

Overfill

Protector--keeps

dishwasher

from overfilling

and is located in the left front

corner of the tub.

Clean occasionally

with household

cleaner

containing

vinegar or bleach to dissolve

any buildup.

Overfill Protector

should move up and

down freely about one

inch. If it does not

move, lift and clean

underneath.

Care of Drain Air Gap

If a drain air gap was installed for your built-in

dishwasher, check to make sure it is clean so

the dishwasher will drain properly. A drain air

gap is usually mounted on countertop and can

be inspected by removing the cover. This is not

part of your dishwasher and is not covered by

warranty.

Property

Damage

Hazard

Freezing temperatures

may cause water

lines to rupture.

Be sure all supply lines to

and circulating lines within dishwasher are

protected.

Failure to do so could result in property

damage.

Winterizing

A dishwasher

left in an unheated

place should

be protected

from freezing.

Have a qualified

person do the following:

To Disconnect

Service:

1. Turn off electrical

power to the dishwasher

at the supply source by removing fuses or

tripping circuit breaker.

2. Shut off water supply.

3. Place a pan under the inlet valve.

Disconnect

water line from inlet valve and

drain into pan.

4. Disconnect

drain line from pump and drain

water into pan.

Note: See Installation

Instructions

for more

details.

To Restore Service:

1. Reconnect

the water, drain, and electrical

power supply.

2. Turn on water and electrical

power supply.

3. Fill both detergent

cups and run

dishwasher

through

a NORMAL

cycle.

4. Check connections

to make sure they do

not leak.

Note: See Installation

Instructions

for more

details.