Gallien-Krueger MB FUSION Manuel du propriétaire - Page 11
Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Gallien-Krueger MB FUSION. Gallien-Krueger MB FUSION 12 pages.
Imprimer la page
Sound Tips
The MB Fusion has several unique features which, if
used properly, will obtain the sound you have been
searching for.
The Equalizer: The Equalizer is used to fine tune
your sound. When adjusting making adjustments, do
it just a little at a time. These are active circuits and
small changes can make a big difference in your
sound. With a little experimentation you will find
that this equalizer is very easy to use and provides
you with a large variety of great sounds unique to
GK.
Contour: Increasing the Contour level will scoop
out midrange frequencies while boosting the highs
and lows. The sound, once again, is unique to GK
and available on any other Bass amp. Lower contour
settings are recommended for midrange clarity at
higher playing levels.
Gain and Master A/B: The Gain A/B settings
determine the overall drive of the signal. Lower
settings will allow for the cleanest sound, while
higher settings will result in an overdriven signal as
the tubes distort. For high volume applications
where maximum headroom is desired, the Master
A/B knobs should be set a 3 o'clock or higher.
MB FUSION
Direct Out: The MB Fusion provides a low noise,
high quality balanced direct output for connection
to PA and recording consoles. A Ground Lift switch
is included to remove hum and buzz when connect-
ing to equipment powered by a different ground
system.
With the Pre/Post EQ switch set to "Pre" (Out), the
direct output signal is fed directly from the input
stage providing a low noise output superior to
external direct boxes and impedance transformers.
In the "Pre" position, the direct output signal is only
effected by the Input Volume, -14db Pad and Mute.
This allows you to adjust your tone and volume on
stage without changing the Direct Output signal
level and confusing your sound man.
Changing the Pre/Post EQ switch to "Post" (In),
sends the "GK Sound" (EQ settings etc.) and
preamp response to the Direct out jack. This gives
you complete control over the Direct out's tone and
volume.
11