AFL MFP Manuel de référence rapide - Page 5
Parcourez en ligne ou téléchargez le pdf Manuel de référence rapide pour {nom_de_la_catégorie} AFL MFP. AFL MFP 17 pages. Multi-fiber identification system
Imprimer la page
3
Wavelength/Backlight Button
3
Note: the Wavelength button only functions when the MFP is in standard power
meter mode. In Fiber ID mode the Wavelength button si disabled, as 1550 nm is
the only wavelength available in the Fiber ID test mode.
In the standard power meter mode the Wavelength/Backlight provides
two functions as follows:
– Press to cycle through the calibrated wavelengths.
– Press and hold to toggle the Backlight On or Off.
dB/dBm/µW Button provides two functions:
4
4
– Press to toggle test readings between insertion loss in dB and power in dBm.
– Press and hold to view power in µW.
Ref/Set Button works in both Fiber ID mode and standard power meter
5
5
mode. It provides two functions:
– Press to display the stored reference level for the currently selected
wavelength or multiple wavelengths.
– Press and hold until [HELD SET] is displayed to store the currently measured
level or multiple levels as the new reference levels. Once the new reference is
set, an MFP switches to the dB measurement mode.
6
LCD Display
6
–
Battery status indicator - displays estimated battery life remaining.
The 3 bars indicate the charge level. When the battery is low, the battery
indicator will flash.
– In Fiber ID mode: displays loss and Fiber ID if detected or "- - -" if no signal.
– In standard power meter mode: displays wavelength and loss or power
measurements.
7
Optical Port - accepts AFL's thread-on adapter cap.
7
MFP Controls and Interfaces
5