Copytrax DaVinci pro 6 photo Manuel de l'utilisateur - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Copytrax DaVinci pro 6 photo. Copytrax DaVinci pro 6 photo 15 pages. High resolution inkjet printer for cd and paper

Imprimer la page
DaVinci Pro CD printer.

Setting up.

1
Output support
3
Location holes
Output support
135cm
Parallel
USB
Locating holes
Pins under
input guide
4
Pins
1.

Space to work.

Prepare an area of desk space to set up the
printer. A space of 135cm wide x 62 cm deep
Input guide
is required.
The desk should be stable and level, in a
place free from dust, humidity, movement,
vibrations and away from direct sunlight.
Place the printer in the centre of the desk
space with the control end of the printer
nearest the front of the desk.
When using the printer you will be working
from the side of the printer and not from the
front as desktop printers are conventionally
used.
2.

Connecting the cables.

Move the input guide aside. Do not connect
the mains cable to the mains supply at this
2
point, but plug it into the rear of the printer.
Plug in either the USB or parallel cable into
the rear of the printer.
Mains
3.

Fitting the input guide.

Locate the 2 pins on the underside of the
Cables
input guide into the location holes on the
metalwork on the rear of the printer.
Ensure that the input guide is sitting level on
the desk top and that the cables pass through
the opening in the side of the input guide and
are not trapped underneath it.
4.

Fitting the output support.

Flex the two wings on the end of the output
support enough to locate the 2 pins on the
support into the 2 location holes in the printer
body.
Ensure that the support sits level on the
desktop and nothing is trapped underneath it.