Galls K9 Partner Manuel d'instruction - Page 10
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Galls K9 Partner. Galls K9 Partner 20 pages. Power door opener
Imprimer la pageK9 Partner Power Door Opener System with PowerTouch Remote Control
Installation: Electrical - Receiver Power & Ground
Disconnect the main battery power of the vehicle before starting installation of this system.
1) Install Power
Connect the Red wire to a constant +12v battery power source. Note: For best performance, run a
clean +12v directly from the battery or a fuse that is NOT supplying any power to motors, lights or
other high current devices, with the noted exception of the actuator supplied in this kit.
2) Install Ground
Connect the Black wire to chassis ground
A) Scrape all paint and grease away from the body frame.
A loose chassis ground connection WILL cause intermittent operation of receiver.
B) Clean the area using an alcohol based cleaner to remove paint chips and grease.
C) Crimp a #10, 3/16" ring terminal onto the black ground wire.
D) Insert the ring terminal and a #10, 3/16" star washer over a 10x3/4" hex head,
self-tapping ground screw.
E) Tighten ground screw securely into clean frame area.
Use ONLY a volt meter to check voltage
during installation and testing.
*Using a test light WILL damage the outputs!
Diagram 10a
PowerTouch Remote Control System
Series 814 RF Receiver
This device complies with FCC rules part 15.
Operation is subject to the following 2 conditions:
1) This device may not cause harmful interference
2) This device must accept any interference received
including that causing undesired operation
36" Gray Antenna Wire
#10 x 3/4" Screw
#10 3/16" Ring Terminal
Scrape paint and clean area before installing ground screw.
A loose chassis ground connection WILL cause intermittent operation!
WARNING:
WARNING!
*Maximum output current 300mA.
Over current will damage outputs.
1
1
2
2
3
3
4
4
5
5
6
6
7
7
8
8
Chassis Ground
#10 3/16" Star Washer
Vehicle Frame
Red
(+) Input +12v Battery Power
Violet
(+) Output Channel 1 - Button 'A'
Pink
(+) Output Channel 2 - Button 'B'
Green/Black
(-) Output Channel 1 - Button 'A'
Yellow/Black
(-) Output Channel 2 - Button 'B'
Brown
(-) Output Channel 3 - Buttons 'A' & 'B'
Blue
(-) Output Channel 4 - Back Button
Black
(-) Input Ground - Connect to Chassis
Ground using External Tooth Washer
Manual C840.N2
Auto Reset Circuit Breaker
10a Maximum
Bat Aux
(-)
(+)
Battery
Page -10-