AGS Merlin 1000Si Manuel d'installation et d'utilisation - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel d'installation et d'utilisation pour {nom_de_la_catégorie} AGS Merlin 1000Si. AGS Merlin 1000Si 16 pages. Gas safety products, gas utility controller
Également pour AGS Merlin 1000Si : Manuel d'utilisation et d'installation (7 pages), Manuel d'utilisation et d'installation (9 pages), Manuel de l'utilisateur (12 pages)

Installation & Operation Manual

INSTALLATION

The Merlin 1000Si is to be used an isolation utility controller that controls the fire pit gas supply

through a solenoid valve and interrupts the line voltage to the panel with a digital

programmable timer providing 7 day automatic control. If either the 1000Si controller is in alarm

condition or any of the remote EPO buttons alarm the gas solenoid valve will close and will only

re-energize once the fault has been cleared. For additional fire pits, a separate digital

programmable timer will provide 7 day automatic control over a single or multiple gas solenoid

valves.

The Merlin 1000Si can work in conjunction with carbon dioxide, natural gas, carbon monoxide

and LPG sensors. The Merlin 1000Si also has a built in "timeout" facility which will automatically

shut off the gas solenoid valve at the end of a specific time period, this time period can be

adjusted to 2, 5, 8 hours or can be overridden if required.

Please refer to your detector manual for important information regarding coverage,

location and positioning including areas and conditions to avoid.

Placing the panel at eye level allows for optimum monitoring of LED Indicators.

Unpack all the parts!

1. Carefully remove the front cover from the unit by unscrewing the four bolts located at each

corner. To do this – use the socket wrench provided.

2. Mark the four screw holes located on the back of the enclosure to the wall. Ensure the wall

surface is flat to prevent base distortion.

3. After executing the mounting and the connections – replace the front cover and insert the

security caps over the four bolts.

Be careful when creating access for cables – Damage to boards will void any warranty.

Carefully remove the circuit board before drilling cable entry holes.

A flush mount kit is available, comprising of a mounting bracket and decorative surround strip.

Contact your supplier for more information.

1000Si IOM Rev: 06

01-20

Merlin 1000Si