Dynex DX-DRTVM102 Manuel de l'utilisateur - Page 13

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Dynex DX-DRTVM102. Dynex DX-DRTVM102 16 pages. Support de montage mural de taille moyenne ultra-mince avec inclinaison de - 5° optionnelle
Également pour Dynex DX-DRTVM102 : (anglais) Manual Assembly Instructions (16 pages), (français) Instructions De Montage Manual (16 pages)

Imprimer la page

DX-DRTVM102

Step 6:

Mount the wall plate (continued)

Note: Any material covering the wall (such as sheetrock) must not exceed 5/8" (16 mm).

Option 2: Mounting on a solid concrete or concrete block wall

Level the wall plate (01) and mark the hole locations.

Drill pilot holes to a depth of 3" (75 mm) using a 3/8 in. (10 mm) diameter masonry drill bit.

Insert concrete wall anchors (06) into the pilot holes and make sure that the anchors are seated flush with the

concrete surface.

Align the wall plate with the anchors. Place washers (05) over the screw holes in the wall plate, insert

lag bolts (04) through the washers, then tighten the lag bolts only until the washers are pulled firmly against the

wall plate.

Warning: Avoid potential injuries or property damage. DO NOT over-tighten the lag bolts (04).

You'll need:

06 (2)

05 (2)

04 (2)

Pencil

Level

Need help? Call 800-305-2204

Drill

3/8" (10 mm)

masonry drill

bit

3" (75 mm)

Never drill into

the mortar

between blocks.

Hammer

Socket wrench with

1/2" (13 mm) socket

or adjustable wrench