Dynex DX-DRTVM114 Manuel d'assemblage - Page 11

Parcourez en ligne ou téléchargez le pdf Manuel d'assemblage pour {nom_de_la_catégorie} Dynex DX-DRTVM114. Dynex DX-DRTVM114 15 pages. Support mural discret pour téléviseurs
Également pour Dynex DX-DRTVM114 : (anglais) Manual Assembly Guide (15 pages), (français) Manual De Montage (15 pages)

Imprimer la page
DX-DRTVM114
STEP 6 - Option 1: Installing on a wood stud wall
Note: Any drywall covering the wall must not exceed 5/8" (16 mm).
1
Locate the stud. Verify the center of the stud* with an edge-to-edge stud finder.
2
Align the wall plate template (D) at the height you determined in the previous step, make sure that it is
level, then tape it to the wall. Use a pencil to mark the lag bolt hole locations (4) on the stud centers.
3
Drill pilot holes to a depth of 3 in. (75 mm) using a 7/32 in. (5.5 mm) diameter drill bit. Remove the wall
plate template.
4
Align the wall plate (A) with the pilot holes, insert the lag bolts (T) through the lag bolt washers (S),
then through the holes in the wall plate. Tighten the lag bolts only until they are firm against the wall
plate.
CAUTION
- Minimum wood stud size: common 51 x 102 mm (2 x 4 in.) nominal 38 x 89 mm (11/2 x 31/2 in.).
- Minimum spacing between horizontal fasteners cannot be less than16 in.
You'll need
Wall plate (A)
Top / Dessus / Vista superior
DX-DRTVM114 Wall Plate Template • Gabarit de la plaque murale • Plantilla de la placa de pared
Top / Dessus / Vista superior
Note: For wood frame installations, use
Tools Needed
Outils nécessaires
Remarque : Pour des installations sur
des structures en bois, utiliser d'abord
Herramientas requeridas
un localisateur de montants pour
détecter un montant en bois.
Nota: para las instalaciones en marcos
de madera, use primero un localizador
de viga para ubicar las vigas de pared.
Wall plate template (D)
: Avoid potential injuries or property damage! DO NOT over-tighten the lag bolts (T).
Pencil
Drill
Important: Make sure that the
lag bolts are inserted into a wood
stud. The distance between two
studs is typically 16".
V1 13-0671
S (4)
3 in.
(75 mm)
7/32" wood drill
bit
Edge-to edge
stud finder
T (4)
1/2" socket wrench
Level
Tape
11