Galvin Engineering Flowmatic TZ-FLOWSENC24B Installation du produit - Page 10
Parcourez en ligne ou téléchargez le pdf Installation du produit pour {nom_de_la_catégorie} Galvin Engineering Flowmatic TZ-FLOWSENC24B. Galvin Engineering Flowmatic TZ-FLOWSENC24B 10 pages. Stainless steel retro fit bluetooth face plate 24v ac, suits enw. sensor
Imprimer la page
Product Installation Guidelines
MAINTENANCE INSTRUCTIONS
Sensor:
The Electronic Sensor is a non serviceable product. If damaged the sensor must be replaced.
−
Turn power off at GPO.
−
Unscrew the two fixing screws. The silicon seal may have to be cut with care to free the sensor.
−
Unplug the solenoid plug and transformer plug from the rear of the sensor. Generally, if the sensor has been
damaged by an electrical surge, it is recommended that the transformer be replaced at the same time.
−
Replace the sensor and reconnect the new sensor. Plug the solenoid and transformer plugs back onto the
rear of the sensor. Fix the sensor panel back onto the galvanised inwall box with the existing screws.
Important: Seal the stainless steel face panel and screws using silicon, ensuring it has a water tight
seal.
Note: Before attempting to replace any of these items check that you have access to re-run the
connection leads. If you do not have access or you have any doubts please contact Galvin Specialised for
advice before commencing replacement.
WARRANTY
The warranty set forth herein is given expressly and is the only warranty given by the Galvin Engineering Pty Ltd.
With respect to the product, Galvin Engineering Pty Ltd makes no other warranties, express or implied. Galvin
Engineering Pty. Ltd. hereby specifically disclaims all other warranties, express or implied, including but not
limited to the implied warranties of merchantability and fitness for a particular purpose.
Galvin Engineering Pty Ltd products are covered under our manufacturer's warranty available for download from
www.galvinengineering.com.au Galvin Engineering Pty Ltd expressly warrants that the product is free from
operational defects in workmanship and materials for the warranty period as shown on the schedule in the
manufacturer's warranty. During the warranty period, Galvin Engineering will replace or repair any defective
products manufactured by Galvin Engineering without charge, so long as the terms of the Manufacturer's warranty
are complied with.
The remedy described in the first paragraph of this warranty shall constitute the sole and exclusive remedy for
breach of warranty, and Galvin Engineering Pty Ltd shall not be responsible for any incidental, special or
consequential damages, including without limitation, lost profits or the cost of repairing or replacing other property
which is damaged if this product does not work properly, other costs resulting from labour charges, delays,
vandalism, negligence, fouling caused by foreign material, damage from adverse water conditions, chemical,
electrical or any other circumstances over which Galvin Engineering has no control. This warranty shall be
invalidated by any abuse, misuse, misapplication, improper installation or improper maintenance or alteration of
the product.
© Galvin Engineering Pty Ltd
Version 1, 8 September 2021, Page 10 of
Version 2, 8 September 2021, Page 10 of 10
10