AGS Carbon Monoxide Installation Fonctionnement et entretien - Page 8

Parcourez en ligne ou téléchargez le pdf Installation Fonctionnement et entretien pour {nom_de_la_catégorie} AGS Carbon Monoxide. AGS Carbon Monoxide 12 pages. Parksafe gas detector

Imprimer la page

Installation, Operation & Maintenance

Operation

First Power Up

On connecting power, your gas detector Power LED will illuminate.

The gas detector then enters a stabilisation phase for approximately 60 seconds – during this time the Fault LED

will flash indicating that the device is not yet ready for operation.

The gas detector will then establish a Modbus data signal with the main control panel – during this time the Fault

LED will remain lit.

When the data signal has established with the main control panel, the Fault LED will switch off and the detector

will be in operation. Check your Parksafe panel for the gas detector status.

We recommend all gas detection systems be commissioned by a competent/trained engineer to ensure

correct installation and operation!

LED Indications



Power

The Power LED will remain illuminated when power to the detector is present.



Fault

An issue with the gas sensing module, i.e. it has been removed/not installed properly or

The gas sensing module has reached the end of its expected lifecycle or

The gas detector annual service.



Alarm

The system is in alarm condition because dangerous gas levels detected.

Alarm Set Points

▲Rising alarm ▼Falling alarm PPM (Parts per Million)

Gas Detector

Carbon Monoxide (CO)

Nitrogen Dioxide (NO2)

Rev: 11

0421

Pre-Alarm

Alarm State

▲ 25ppm

▲ 100ppm

▲ 0.7ppm

▲ 2.0ppm

Parksafe Gas Detector