Galvin Specialised 42030 Manuel d'installation des produits - Page 3
Parcourez en ligne ou téléchargez le pdf Manuel d'installation des produits pour {nom_de_la_catégorie} Galvin Specialised 42030. Galvin Specialised 42030 6 pages.
Imprimer la page
Product Installation Guideline
4. Remove faceplate
Unscrew dome flange.
Slide off faceplate.
7. Check & Clean the body
Check and clean the body of all debris.
WARRANTY
The warranty set forth herein is given expressly and is the only warranty given by the Galvin Engineering Pty Ltd. With respect to the product,
Galvin Engineering Pty Ltd makes no other warranties, express or implied. Galvin Engineering Pty. Ltd. hereby specifically disclaims all other
warranties, express or implied, including but not limited to the implied warranties of merchantability and fitness for a particular purpose.
Galvin
Engineering
Pty
Ltd
www.galvinengineering.com.au
workmanship and materials for the warranty period as shown on the schedule in the manufacturer's warranty. During the warranty period,
Galvin Engineering will replace or repair any defective products manufactured by Galvin Engineering without charge, so long as the terms of
the Manufacturer's warranty are complied with.
The remedy described in the first paragraph of this warranty shall constitute the sole and exclusive remedy for breach of warranty, and Galvin
Engineering Pty Ltd shall not be responsible for any incidental, special or consequential damages, including without limitation, lost profits or
the cost of repairing or replacing other property which is damaged if this product does not work properly, other costs resulting from labour
charges, delays, vandalism, negligence, fouling caused by foreign material, damage from adverse water conditions, chemical, electrical or any
other circumstances over which Galvin Engineering has no control. This warranty shall be invalidated by any abuse, misuse, misapplication,
improper installation or improper maintenance or alteration of the product.
5. Remove handle
Losen grub screw.
Unscrew handle.
8. Re-assemble
Re-assemble, by reversing steps
6 to 1 ensuring sealing compound is
used when connecting water supply and
outlet.
products
are
covered
under
Galvin Engineering Pty Ltd expressly warrants that the product is free from operational defects in
6. Remove face plate nut and check
cartridge
Unscrew face plate nut and remove
cartridge.
Check the cartridge for wear and
damage. Replace if required with
cartridge replacement kit available
through your supplier
(use of incorrect cartridge could stop
shower from working).
9. Re-test
Once fully assembled turn on water
supply.
Check for leaks and correct operation.
our
manufacturer's
warranty
Version 16 February 2017 Page 3 of 3
available
for
download
from