Corally C-00257C Manuel de démarrage rapide - Page 8
Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Corally C-00257C. Corally C-00257C 19 pages. 1/10th scale elctronic ready to run
Imprimer la page
MAINTENANCE
SLIPPER PAD REPLACEMENT
It may be necessary to replace the slipper pad every 25 runs.
It depends on how you drive and the type of terrain you drive on. If after consecutive adjustments you have motor problems, it is necessary to change the PADS.
Remove the cover
SLIPPER CLUTCH ADJUSTMENT
Remove the cover
SPUR AND PINION MESH ADJUSTMENT
If the gear mesh is not correct, you wear out the spur gear prematurely, the transmission will make noise, give unnecessary load on the motor (higher consump-
tion, heating of the transmission).
Loosen the motor screws.
8
Loosen the Nylstop nut.
Tighten or loosen the nut to have 3mm of visible
shaft.
Cut a 5mm wide strip of paper and run it between
the pinion and the spur gear.
Replace the slipper pad #C-00250-088
Re-tighten the motor screws and then remove the
strip of paper.