Galvin Specialised Ezy-Drink TD90C Manuel d'installation des produits - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel d'installation des produits pour {nom_de_la_catégorie} Galvin Specialised Ezy-Drink TD90C. Galvin Specialised Ezy-Drink TD90C 4 pages. Remote bubbler tapware

INSTALLATION
IMPORTANT: Galvin Specialised products must be installed in accordance with these installation instructions and
in accordance with AS/NZS 3500, the PCA and your local regulatory requirements. Water and/or electrical supply
conditions must also comply to the applicable national and/or state standards. Failing to comply with these
provisions shall void the product warranty and may affect the performance of the product.
1. Fit tap assembly
− The drinking taps are fitted with flow restrictors.
When applying thread tape or sealant to the
inlet, ensure the opening is not obscured.
Failure to do so may restrict or block the flow
restrictor, affecting the flow of water.
3. Testing
− Once the drinking tap has been installed and tested for leaks, the water height must be adjusted to suit the
available pressure.
− To adjust water flow
1. Remove the blanking screw
2. Adjust the water height by turning the regulator screw
3. Replace blanking screw
Note: The full range from minimum flow to maximum flow is only ¼ turn
2. Secure the body
− Secure the body with supplied screws.
− Ensure outlet is 15° angled.
Version 1, 31 October 2016, Page 2 of 4