Mail Boss 43" In Ground Post Instructions

Parcourez en ligne ou téléchargez le pdf Instructions pour {nom_de_la_catégorie} Mail Boss 43" In Ground Post. Mail Boss 43" In Ground Post 2 pages.

Imprimer la page

1/2

43" In Ground Post

The USPS is the ultimate authority on mailbox installations, and in some cases if you are located on a high-speed road there may be additional rules or guidelines set in place by your local

municipality or transportation department. If you are unsure about the location of your mailbox or the details of your installation, please reach out to your local post o ce before installing

the post/ mailbox to ensure the correct placement and height at the street.

Tools Required:

Shovel

13mm or 1/2" Wrench (socket or crescent)

Tape Measure

Concrete (Fast-setting preferred)

Large bucket & water (to mix concrete)

Level

Wood plank & masking tape (for bracing)

Accessories:

Height

Extender

Depth

Newspaper

Extender

Holder

These Instructions are only guidelines

**Always check with your local utility companies before digging.**

Dig a hole 18 to 20 inches from the edge of the road surface.

Refer to the diagram on the reverse of this page for post depth

and placement guidelines.

Mix and pour concrete. Using your level, con rm you are at the desired

position. Once concrete is set, remove the brace and install your Mail Boss

mailbox or spreader assembly.

Have a question?... Need a part ASAP?...1-800-589-7990

18" to 20"

Road surface

soil

Place the post into the hole at the required location and

make sure that the at portion of the post is parallel to the

road. Use a wood plank and masking tape to temporarily

brace the post in place. Ideally, level the top of the post so

that the front of the mailbox will be 0.5° - 1° lower than the

rear, this will allow water to shed o the front overhang of

the mailbox.

11-Jan-2023