AGS Mini Merlin Manuel d'installation et d'utilisation - Page 7
Parcourez en ligne ou téléchargez le pdf Manuel d'installation et d'utilisation pour {nom_de_la_catégorie} AGS Mini Merlin. AGS Mini Merlin 16 pages. Ch4 co: dual gas detector methane & carbon monoxide
Également pour AGS Mini Merlin : Manuel de l'utilisateur (16 pages), Installation Fonctionnement et entretien (20 pages)
Imprimer la page
Installation & Operation Manual
Mounting
Unpack all the parts!
This device is designed for either surface mounting, or
mounted on a one or two gang electrical box and must be
installed by a licensed, insured contractor.
This device comes with a deep base back cover and barrier slip to maintain segregation
between high and low volt connections. A flush mount base is available – Contact your
supplier for more information.
1. Carefully remove the rear cover from the unit by releasing the two latching clips with a small
flathead screwdriver.
2. Using the rear cover - mark the screw holes to the wall or align with the electrical box. If
mounting direct to wall - ensure the wall surface is flat to prevent base distortion.
3. There are pre-fractured areas for cable entry and barrier to separate low and high volt
connections.
4. Mount at 5 feet from ground level and in accordance with any applicable regulations.
5. After executing the mounting and connections – secure the rear cover.
Take care when making connections to high voltage connectors!
Any damage attempting to remove the circuit board may void any warranty!
All Class 2 wiring is to be installed within flexible tubing to maintain segregation between circuits!
Wiring of different circuits shall be separated from each other by means of routing, clamping or barrier!
Rev: 11 08-20
All wiring shall be made of copper!
Mini Merlin
7