CORBERO CF2PG148RR Manuel d'instruction - Page 10
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} CORBERO CF2PG148RR. CORBERO CF2PG148RR 13 pages.
Imprimer la page
4. Raw food and cooked food need to stored in different containers. In order
to prevent bacterial contamination, raw vegetables and fruits should not
be exposed to raw meat or fish. Vegetables and fruits should be wrapped
by film and stored in the crisper.
5. Before freezing, the food,separated from raw and ripe,should be
wrapped tightly with fresh-keeping film, and placed in different containers.
The temperature of freezing room is - 18°C Meat should be kept in fresh
and fish in deep-frozen. In order to make the taste fresh and delicious, and
to lock up the nutrition of food, the food in the refrigerator should not be
stored for more than three months.
INSTALLATION INSTRUCTIONS
1.
The refrigerator should be located in a completely flat surface , Leave 5~10 cm
between each side of the appliance and the wall, and leave 30 cm between the top
of the appliance and the ceiling.
2.
Choose a location which is not exposed to sunlight ,
high temperature or humid , as humidity maycause stain.
3.
Pulled out the bottom panel before installation.
4.
The appliance can be adjusted by rolling its two legs in
front the bottom when it is unstable. Rolling in clockwise
can rise up the machine.
5.
The location should be firm and flat. An un-securely
position may cause noise and libration:
(a)The noise may be increased if the floor is not firm.
(b) Put a sheet under the appliance for solving the heat
emission if you need to locate it onto a carpet.
6.
Make sure the adjustable legs are clung to the floor,
and set the appliance slope backward slightly for keeping the doors closed tightly.
OPERATION INSTRUCTIONS
PLACEMENT OF FOOD
1.
There should always be some space between items inside for air circulation.
2.
Food should be kept in sealed package to avoid becoming
dry or with odour.
3.
Hot food should be cooled down before placing into the
appliance. Otherwise, interior temperature and electronic
consumption will increase.
4.
Reduce the frequency of door opening can efficiently low
down the electronic consumption.
Warning
Do not use any electronic equipment inside the appliance.
4
INSTRUCTION FOR USAGE
The temperature of refrigerator can be controlled manually by the knob. However,
the number shown on the knob does not directly represent the temperature. Instead,
the larger the number is, the lower the interior temperature will be. 0 stands for off. Turn
the knob to state 4 when it is normal used, turn it to the state during 4-7 if a lower interior
temperature is required; contrarily, to the state during 4-1, when a higher one is needed.
PACKING AND MOVING
1.
Unpack , repack and carry
Please memorize the position of each accessory of the appliance
when unpack it, repack the product and check it carefully before
transportation.
2.
Do not lift or pull the door or the door handle during transportation.
3.
When moving, the appliance can not be sloped over 45 degrees
(the angle to the vertical direction). Please avoid strong vibration
and hit.
MAINTENANCE
The appliance should be maintained and cleaned frequently. For your safety,do
please pull the plug out of the socket before the cleaning.
1.
Interior maintenance
Clean the interior of the appliance with clean water or neutral abluent.Scour it with
clean water and wipe it with a piece of dry cloth.
2.
Maintenance of door gasket
It is easy to damage if the door gaskets are polluted by the stain like oil, sauce and
etc., so it is better to clean them carefully.
3.
Outer maintenance
Wipe the dusty with a piece of dry cloth ,clean it with neutral abluentif necessary.
4.
The displacement of interior light Uninstall the cover and replace the light with a
screwing light (E14 , 220V/10W)，Consult the following pictures：
①. Pry the bolt on the thermostat
away from the lamp shade about
2mm with the tool.
③.Take out the lamp shade along
the direction of the arrow.
②.Meanwhile take another side
as the center to ratote the lamp
shade outwards.
④.Rotate and take out the bulb in
counterclockwise direction.
5