GAMA Electronics LRF240VPR1L Manuel d'instruction - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} GAMA Electronics LRF240VPR1L. GAMA Electronics LRF240VPR1L 4 pages.
Également pour GAMA Electronics LRF240VPR1L : Manuel d'instruction (4 pages)

GAMA Electronics LRF240VPR1L Manuel d'instruction
LRF240VPR1L
Instruction Manual
WWW.GAMAINC.COM
Each transmitter has its own unique internal address along with the data as to which button is
pressed and transmitted. The receiver needs to be programmed to respond only to the specific
transmitter it is intended to operate with. The following steps configure the receiver to operate with a
particular transmitter. Up to 30 transmitters can be programmed to one receiver. Please read the
entire programming procedure before starting. When the receiver enters program mode, all previous
transmitter addresses that were programmed will be erased from the receiver's memory.
1. Locate the pushbutton labeled "PROGRAM" on the receiver. Press and hold this button until the
red LED next to the program button illuminates (approximately 3 seconds). The receiver is now in
the transmitter program mode. Release the button. At this point, all previously programmed
transmitter addresses are erased from the receiver's memory.
2. To configure the receiver fro latching output, go to Step 4.
3. To configure the receiver for momentary output, press and release the UP button on the
transmitter and verify that the red program LED extinguishes and then illuminates (blinks once).
Proceed to Step 5.
4. To configure the receiver for latching output, press and release the DOWN button on the
transmitter and verify that the red program LED extinguishes and illuminates (blinks once).
5. Repeat the previous step for additional transmitters that will operate with this particular receiver.
The red LED on the receiver will extinguish and illuminate (blink once) for the first transmitter being
programmed, twice for the second, three times for the third, etc. The receiver will not respond to
transmitters that have already been programmed. The first transmitter that is programmed
determines the receiver's relay operating mode.
6. The receiver will return to normal mode if no transmitter buttons are pressed for 5-seconds. The
red LED on the receiver will blink rapidly, then extinguish. The receiver is now in the normal mode of
operation. This completes the programming instructions. The receiver will retain all of its
programming even when power is removed.
Power Terminals
Programming Switch
Programming LED
Page 2 REV A 04/22/20
Long Range
Isolated Output Contacts
Antenna Jack