Main Multipoint BF Instructions d'utilisation, d'installation et d'entretien - Page 11
Parcourez en ligne ou téléchargez le pdf Instructions d'utilisation, d'installation et d'entretien pour {nom_de_la_catégorie} Main Multipoint BF. Main Multipoint BF 20 pages. Gas fired balanced flue water heater
Imprimer la page
6 720 607 090
9.1
combustion air.
9.2
compartment.
9.3
appliance to allow proper circulation of air. The clearences
required for operation will normally be adequate.
9.4
information.
10. 1
BS 6891.
10.2
compression via the gas isolation valve supplied.
10.3
appliance is of adequate size. If the appliance gas rate cannot
be achieved, the specified hot water conditions will not be
reached.
11.1
If an existing flue terminal is not being used, refer to the flue
installation instructions on the wall template.
11.2 This appliance is suitable for installation in conjunction
11.3 Unpack the appliance and take care to remove the
11.4 Lay the appliance on its back and unscrew the
Fig. 9
9. Air Supply
The appliance does not require a separate vent for
The appliance may be installed in an unvented
There must be sufficient clearance around the
Refer to BS 6798 and BS5440:2 for additional
10. Gas Supply
The gas installation should be in accordance with
The connection to the appliance is 15mm
Ensure that the pipework from the meter to the
11. Installation
FLUE INSTALLATION
with a "SEDUCT" flue system that complies with the
requirements of BS 5440 - 1 2000 & IS 813:2002. For
"SEDUCT" installations flue kit part no. 31/12968 and
pilot kit 5113785must be used.
These kit contain instructions referring to installations
with "SE DUCT" flue systems and the appliance
conversion procedure.
installation kit which is packed on top of the polystyrene
packing
The installation kit consists of the following:
Gas inlet:
1x Copper inlet elbow, Compression Nut, fibre washer
1x Isolation valve, 2 x Compression nuts and Olives
Water Inlet:
1x Copper inlet elbow, Compression Nut, fibre washer
1x Isolation valve, 2 x Compression nuts and Olives
Water Outlet:
1x Flanged Copper Pipe, Compression nut, Fibre washer
Temperature Control Knob Bezel.
11