CORBERO ZD19/4R-3 Manuel rapide - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel rapide pour {nom_de_la_catégorie} CORBERO ZD19/4R-3. CORBERO ZD19/4R-3 14 pages.

Imprimer la page

Installation

Positioning

• Place the refrigerator away from direct sunlight and

heat sources.

• Maintain recommended ventilation - see Fig. 1.

• Make sure the refrigerator is accurately levelled tur-

ning the adjustable feet in order to avoid vibrations

and noises Fig. 2.

• This is a built in design to be aligned with other fur-

niture.

• The appliance should be only set up at a location

whose ambient temperature corresponds to the cli-

mate classification, for which the appliance is desig-

ned.

• The climate classification can be found on the serial

plate of the appliance.

• The following table shows which ambient tempera-

ture is correct for each climate classification:

Climate classification

• However, the manufacturer make sure the correct

operation of the appliance from minimum tempera-

ture of 10°C to upper limit of each climatic class.

Cleaning the interior

• Do not use alcohol or any cleanig product containing

alcohol because it can damage the cabinet.

• Before using the appliance for the first time wash the

interior whith luke warm water and some neutral

soap so as to remove the typical smell of a brand-

new product and then dry thoroughly.

• Do not use detergents or abrasive powders as these

will damage the finish.

• Remove security used for transportation.

Electrical connection

mBefore plugging the appliance into a socket make

sure that the voltage and frequency shown on the

rating plate correspond to your home supply.

mIt is essential that the appliance be connected to an

efficient earth tap.

For this purpose the supply cable plug incorporates a

special earth contact. If the sockets of your domestic

for an ambient temperature of

+ 10 to + 32°C

+ 16 to + 32°C

+ 18 to + 38°C

+ 18 to + 43°C

wiring system are not grounded, have the

appliance connected to a separate ground wire in

accordance with existing safety regulations.

«THE MANUFACTURER DECLINES TO

ACCEPT ANY LIABILITY IF THIS SAFETY

RULE IS NOT OBSERVED».

Starting – up

• Plug the appliance into the mains.

• Turn to intermediate position the knobs of the

«temperature regulators» «A» Fig. 5.

• Make sure the inner light «H» turns on when

opening de door.

Fig. 1

Fig. 2