GAMA Electronics T-SC-12V Manuel d'instruction - Page 2
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} GAMA Electronics T-SC-12V. GAMA Electronics T-SC-12V 4 pages.
Imprimer la page
WWW.GAMAINC.COM
Each transmitter has its own unique internal address along with the data as to which button is pressed and transmitted.
The receiver needs to be programmed to respond only to the specific transmitter it is intended to operate with. The
following steps configure the receiver to operate with a particular transmitter. Up to 12 transmitters can be programmed
to one receiver. Please read the entire programming procedure before starting. When the receiver enters program
mode, all previous transmitter addresses that were programmed will be erased from the receiver's memory.
1. Locate the pushbutton labeled "PROGRAM" on the receiver. Press and hold this button until the red LED next to the
program button illuminates (approximately 3 seconds). The receiver is now in the transmitter program mode. Release
the button. At this point all previously programmed transmitter addresses are erased from the receiver's memory.
2. To configure the receiver for a latching output, go to Step 4.
3. To configure the receiver for momentary output, press and release either the reverse button or the forward button on
the transmitter once and verify that the red program LED extinguishes and then illuminates (blinks once). Proceed to
Step 5.
4. To configure the receiver for latching output, press and release either
transmitter twice and verify that the red program LED extinguishes and illuminates (blinks twice).
5. Repeat previous step for additional transmitters that will operate with this particular receiver. The red LED on the
receiver will extinguish and illuminate (blink) once for the first transmitter being programmed, twice for the second, three
times for the third, etc. The receiver will not respond to transmitters that have already been programmed. The first
transmitter that is programmed determines the receiver's relay operating mode.
6. The receiver will return to normal mode if no transmitter buttons are pressed for 5-seconds. The red LED on the
receiver will blink rapidly, then extinguish. The receiver is now in the normal mode of operation. This completes the
programming instructions. The receiver will retain all of its programming even when power is removed.
Program Switch
Long Range
Antenna Jack
Programming Instructions
LED Indicator
+
T-SC-12V
Instruction Manual
the reverse button or the forward
DECREASE
INCREASE
Forward Button
Reverse Button
STOP
WWW.GAMAINC.COM
Page 2 REV A 06/03/19
button on the