Gama Sonic GS-113W Manuel d'instruction - Page 3
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Gama Sonic GS-113W. Gama Sonic GS-113W 4 pages. Flora solar lamp
Imprimer la page
Installation Instructions
GS-113F
NOTE: If you are replacing an existing gas or electric light, you must consult a
certified technician to disconnect the gas or electricity before installation of solar
lamp.
Place solar lamp on top of your existing 3" post and tighten the 3 screws
provided to secure the lamp.
GS-113P
Using the anchors screws, if needed,
1. Use electric drill to make two holes in the desired surface that match
the holes on the solar lamp base.
2. Place the provided screw anchors into holes.
3. Place the lamp base in line with the holes and screw the base onto your
desired surface with the provided screws.
GS-113W
NOTE: locate your solar lamp facing the south for best results.
Using the screw anchors, if needed:
1. Remove wall lamp support piece by unscrewing the bronze screw caps
from the back of the wall unit.
2. Use electric drill to make two holes in the desired location which
match the holes on the lamp support piece, and place provided anchors
into holes.
3. Place the wall lamp support piece in line with the holes and screw in
using the provided screws.
4. Attach solar lamp to wall support piece and secure with bronze screw
caps.
Replacing the Batteries
(After several years of use, the battery may need replacing).
1. Unscrew the two screws and detach part (A) from part (B). Make sure
the ON/OFF switch (Fig. 1) is in the OFF position.
2. Unscrew the battery compartment screw located on the silver reflector
and remove the battery compartment door.
3. Unclip the connector and remove the old battery. Make sure the new
battery is high quality 3.2V/1,500mAh Li
with connector.
4. Clip on new battery and install into the battery compartment. Screw
back battery compartment door.
5. Reattach part (A) to part (B) and secure with the 2 screws.
-ion
Rechargeable battery