Corbin Russwin Access 800 Manuel d'instructions d'installation - Page 8
Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} Corbin Russwin Access 800. Corbin Russwin Access 800 17 pages. Cl33800 tcac2 series cylindrical lockset
Également pour Corbin Russwin Access 800 : Manuel d'instructions d'installation (16 pages), Instruction de programmation (16 pages)
Imprimer la page
5
Installation of Inside Escutcheon
NOTE: Connectors go on only one way. Do not offset connector and be sure they are completely seated.
1. Connect Ground wire to Ground terminal, Keypad ribbon cable connector to controller, and lockbody
harness to motor connector. If you have a turnpiece, connect the male turnpiece switch connector to
the female turnpiece switch connector.
2. Align turnpiece to the vertical position.
3. Feed excess lockbody harness wire back into the mortise of the door between the door cavity and
lockbody, making sure no excess wire enters the cylinder hole of the lockbody. (see diagram page 8)
Push excess keypad ribbon cable into the ribbon cable hole.
NOTE: For RF Technology versions refer to Section 5 to install through bolt screws.
Motor connector
1
Turnpiece male switch
connector - for non
turnpiece mortise locks
the turnpiece male
switch connector may
be placed in the space
below the controller and
remain disconnected
Female turnpiece
switch connector
Locate (3) oval head screws
and insert through the
Escutcheon and thread
into the outside Escutcheon.
Installation Instructions
Keypad harness
(ribbon cable)
Ground Terminal
Remote Power
Connector
(M35 Remote Power
Wiring Harness also
available as part
No. 793F069)
Lockbody Harness
Red & Black wires
Controller
Turnpiece
micro switch
C A U T I O N
DOOR MUST REMAIN OPEN
DURING INSTALLATION.
USE DOOR STOP.
Turnpiece
Gasket
Ground
Wire
Lockbody
Harness
Male turnpiece
switch connector
GASKET APPLICATION:
Peel off the adhesive protective paper from
gasket. Feed Trim assembly motor harness
through gasket opening as shown and firmly
press gasket to escutcheon, aligning edge of
gasket with the edge of the escutcheon.
7
Inside
of door
Keypad ribbon
cable