Adesys SVL0400-I Manuel - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Adesys SVL0400-I. Adesys SVL0400-I 14 pages.

Imprimer la page

Adesys B.V. | Wateringen

3.4.2 Recovery report (idle)

If desired, a recovery report SMS can be sent after the input goes into idle mode. The default setting is off

even if nothing has been selected. Select 'Yes' to activate this notification. A recovery report will always be

sent to the external server.

3.4.3 System errors

Various system errors can be detected by the SVL. Notifications can be set up individually for each error.

Depending upon the error, this is displayed in the programming tool and a notification is sent via SMS. By

default the notification of all system errors via SMS is switched off.

3.5

Connections

The term 'connections' is used to mean the connection to an external server. With the SVL it is possible to

make a connection to Checkmyproces.com or to a dedicated server.

3.5.1 Checkmyproces.com

Checkmyproces is a server on which the status of the SVL can be logged and is displayed via the cloud.

After logging in, SVL dialers can be connected to the account. This connection takes place via the IMEI

number. The IMEI number can be obtained via SV-prog in the status screen.

Remote configuration

It is possible to remotely make changes to the settings of the dialer. This is possible by ethernet and by

4G/GPRS. For using remote configuration it is necessary to have a constant connection. When using 4G/

GPRS keep in mind of the extra cost.

If the network is secured by use of a firewall. Please make the following exceptions.

Data connection

URL

http://svx.meetcentrale.nl:80/severa

Protocol :

http

Port

System settings

URL

mqtt.meetcentrale.nl

Protocol :

mqtt

Port

1883

3.5.2 Own server

It is also possible to enter your own server IP instead of Checkmyproces.com. Log data and status are then

sent to this IP address. The connection to your own server is made via two paths. The message is sent via

HTTP POST and the settings via MQTT. For more information please contact Adésys.

3.5.2 Connection interval

This is the interval at which data is sent to the server, either via Ethernet or 2G/4G. If both are switched off,

no data will be sent. If both connections are connected and correctly set up, Ethernet will be used as the

main connection type and 2G/4G will serve as a back-up in case a connection via Ethernet is not possible.

3.6

System

In the system section you can change the general SVL settings, enter GSM and mobile data settings or

trigger a factory reset.

3.6.1 Device

In this window you can change device-specific settings such as device name, alarm active text, alarm

recovery text, automatic updates, periodic reset and a periodic report.

3.6.2 Ethernet

Ethernet can be set up with a DHCP server or with the IP, DNS and gateway entered by the user. When an

error occurs it is possible to reset the DHCP by pushing the reset key for a duration of 3 seconds, releasing

it 3 seconds and doing this 3 times. After which the leds wil show restart sequence.

3.6.3 GSM and mobile data

Here, the GSM module can be switched off, the PIN code entered, 2G/4G mobile data switched off or the

data from the APN set up. Please contact your provider for the APN settings.

Manual SVL 4G Weblogger

Page 8