aireRyder F0018 Manuel - Page 7
Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} aireRyder F0018. aireRyder F0018 8 pages.
Imprimer la page
WARNING:
As per EPACT 2005 requirements, this fan light has a built-in current limiting device to conserve
energy. The fan light will not operate if the combined wattage of the installed bulbs exceeds 190
Watts. If the fan light shuts off shortly after being switched on, it may be due to excessive current
demand. You should replace the light bulbs with lower wattage bulbs.
Fig.14
HI
HI
MED
MED
LOW
LOW
OFF
OFF
Frequency
Battery Cover
Fig.15
1 key in upward position:
4
1
2
3
4
1
2
1
2
3
2 keys in upward position:
2
3
4
4
2
1
1
2
3
1
3 keys in upward position:
4
2
3
4
1
2
1
2
3
1
4 keys in upward or downward position:
2
3
4
2
3
4
1
1
Transmitter
Setter
3
4
2
3
4
1
3
4
4
1
2
3
1
2
3
4
3
4
1
2
3
4
Step 1: Set the frequency.
The frequency setter is located under the battery cover.
Initially, all 4 keys are set in upward position. If more than one
remote-controlled fan is installed or if frequency interference occurs,
the fan may function abnormally. In this situation, reset the fan
frequency as follows:
1. Remove battery cover.
2. Use a pen (or any convenient tool) to switch keys to select a
frequency mode which will not interfere with other electronic
devices. There are 15 frequency modes available excluding the
original ex-factory mode (see Fig.15).
Note: Set different remote-controlled fans in one building at different
frequency modes.
Step 2: Program the fan
1. Install two AAA batteries (not included) into the transmitter.
2. Turn on the power to the fan.
3. Within 30 seconds after power is turned on, press and hold the
"OFF" button for 5 seconds. Once the code has been set
successfully, the fan will make a "beep" sound.
Step 3: Operate the transmitter
* Press "HI" to turn on the fan to high speed.
* Press "MED" to turn the fan to medium speed.
* Press "LOW" to turn the fan to low speed.
* Press "OFF" button to turn off the fan.
* Press and release the "
light.
* Press and hold the "
desired level.
Important: Energy saving (CFL) light bulbs are not
recommended for this item.
Note: This remote control has a memory function for the fan light.
*
If the fan light is switched off using the remote control, it will
return to the same level of brightness when switched on again.
1
2
3
4
*
If the power is switched off using the main power switch, the
light will turn back on to full brightness when the main power
is switched on again.
Page: 7 / 8
"button quickly to turn on or turn off the
" button to dim or brighten lights to the
F
F
A
A
N
N
140225
C
C
O
O