Gamber Johnson Leg Kit - Freightliner M2 Instructions d'installation et manuel du propriétaire - Page 3
Parcourez en ligne ou téléchargez le pdf Instructions d'installation et manuel du propriétaire pour {nom_de_la_catégorie} Gamber Johnson Leg Kit - Freightliner M2. Gamber Johnson Leg Kit - Freightliner M2 3 pages.
Imprimer la pageTo Install:
1. Remove the inner seat bolts and loosen the outer seat bolts on both the driver and
passenger seats using an M6 allen wrench.
2. Lift the seat up and slide the legs between the seats and floor.
3. Reinstall the inner seat bolts. Do not tighten the seat bolts yet. This will allow some
flexibility when installing the risers to the leg kit.
4. Install the risers onto the leg kit using the 3/8-16 bolts and 3/8 washers in the hardware
bag. The 2" tall riser should be installed in the rear with the 3" riser installed in front.
NOTE: The risers can be installed into either PEM position onto the leg kit and facing either
forward or backward to provide flexibility when mounting the top plate.
5. Tighten all seat bolts using an M6 allen wrench.
6. Adjust the top plate brackets bolted to the risers left or right depending on the desired
top plate postion. Tighten once they are in the final position. Install the top plate onto the
top plate brackets using the 3/8-16 bolts and 3/8 washers in the hardware bag.
7. Install the front support leg into the farthest forward slot on the top plate using the 3/8-16
bolts and 3/8 washers in the hardware bag. Loosen the side bolts to adjust the height so
that it is tight against the vehicle floor then retighten.
LEG KIT WITH TOP PLATE INSTALLED