Gamber Johnson Notepad V-LT Instructions d'installation - Page 3

Parcourez en ligne ou téléchargez le pdf Instructions d'installation pour {nom_de_la_catégorie} Gamber Johnson Notepad V-LT. Gamber Johnson Notepad V-LT 5 pages. Universal cradle & accessories

Imprimer la page

Adjusting Notepad™V-LT for computer

If the latch on Notepad™V-LT is locked,

unlock the unit with the supplied keys.

All Notepad™V-LT's are keyed alike.

Unlatch by turning the lock body

clockwise 90 degrees.

Pull the lock side of the Notepad™V-LT

to the right to open the deck.

Loosen adjustment screws securing

front clips, rear clips and side clips

enough to raise them and move them in the slots.

Eight Vinyl Caps are included in hardware bag

to place over clips to protect computer if needed.

Place the computer on the Notepad™V-LT deck.

Slide the computer tight against the Front Clips.

The Front Clips can be adjusted side-to-side and

also have a slight amount of vertical adjustment.

The Flat and Offset clips may also swap positions,

with the offset clip overlapping the fixed deck to

accomodate shorter depth computers.

Slide the computer against the Side Clips on the fixed deck.

Adjust the Side Clips side-to-side to avoid any needed ports

and lower them so the tab will just clear the top of

the computer and tighten. A snug fit is prefered.

Push the right side of the Notepad™V-LT in

until the right Side Clips touch the computer.

Adjust the right Side Clips in the same

manner as the left side.

After pushing the unit together,

(compressing the computer between the

side clips) turn the lock body 90 degrees

counter-clockwise to secure the unit.

Adjust the Rear Supports side-to-side

and tighten.

Adjust the Rear Clips to prevent the

computer from moving back and tighten.

Pull to open deck

Unlock and turn lock body

Adjustment Screw

Optional Vinyl Caps

3 / 5