HIKOKI G 3613DA Manuel d'instructions de manutention - Page 11

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions de manutention pour {nom_de_la_catégorie} HIKOKI G 3613DA. HIKOKI G 3613DA 20 pages.
Également pour HIKOKI G 3613DA : Manuel d'instructions de manutention (20 pages)

HIKOKI G 3613DA Manuel d'instructions de manutention
NAMES OF PARTS (Fig. 1–Fig. 15)
Motor
Nameplate
Lock pin
Side handle
Gear cover
Depressed center
wheel
M5 screw
Wheel guard
Switch knob
Dial
Filter
Battery
M5 hex. socket bolt
Switch lever
Latch
SYMBOLS
WARNING
The following show symbols used for the machine.
Be sure that you understand their meaning before
use.
G3610DA / G3613DA / G3613DB:
Cordless Disc Grinder
To reduce the risk of injury, user must read
instruction manual.
Always wear eye protection.
V
Rated voltage
n
Rated speed
n
No-load rotation speed
0
/min
Revolution or reciprocations per minute
Switching ON
Switching OFF
Disconnect the battery
Warning
Remaining battery indicator switch
Charge indicator lamp
Battery level indicator
switch
Battery level indicator
lamp
Lever
Hex. bar wrench
Wheel washer
Wheel nut
Wrench
With side guard
Abrasive cutting
wheel
Off -lock lever
Rubber cover
USB port
USB cable
11
Battery
Lights ;
The battery remaining power is over 75%
Lights ;
The battery remaining power is 50%–75%.
Lights ;
The battery remaining power is 25%–50%.
Lights ;
The battery remaining power is less than 25%
Blinks ;
The battery remaining power is nearly empty.
Recharge the battery soonest possible.
Blinks ;
Output suspended due to high temperature.
Remove the battery from the tool and allow it to
fully cool down.
Blinks ;
Output suspended due to failure or malfunction.
The problem may be the battery so please
contact your dealer.
STANDARD ACCESSORIES
In addition to the main unit (1 unit), the package contains the
accessories listed on page 18.
Standard accessories are subject to change without notice.
APPLICATIONS
○ Removal of casting fi n and fi nishing of various types of
steel, bronze and aluminum materials and castings.
○ Grinding of welded sections or sections cut by means of
a cutting torch.
○ Grinding of synthetic resins, slate, brick, marble, etc.
SPECIFICATIONS
1. Power tool
G3610DA
Model
Voltage
Rated speed
Outer dia.
100 mm
Wheel
Hole dia.
Thickness
Peripheral speed
Battery available
for this tool*
Weight
* Existing batteries (BSL3660/3620/3626, BSL18xx series,
etc.) cannot be used with this tool.
NOTE
Due to HiKOKI's continuing program of research and
development, the specifi cations herein are subject to
change without prior notice.
G3613DA
(2XCP)
(NN)
(NN)
36 V
Transmission mode:
3000–9500 /min
Auto mode:5500 /min
125 mm
16 mm
22.23 mm
6 mm
72 m/s
80 m/s
BSL36A18
2.6 kg
2.8 kg
G3613DB
(2XCP)
(NN)