Gree SOLEUSAIR SG-WAC-06ESE Manuel - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Gree SOLEUSAIR SG-WAC-06ESE. Gree SOLEUSAIR SG-WAC-06ESE 15 pages. Electronic window air conditioner

Imprimer la page

ELECTRICAL REQUIREMENTS

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove the ground prong.

Do not use an adapter

Do not use an extension cord.

Failure to follow these instructions can result in death,

fire, or electrical shock

Recommended Ground Method

For your personal safety, this air conditioner must be grounded. This air conditioner is equipped with a 3 prong power

supply cord with a grounded plug. To minimize the possibility of electrical shock, the cord must be plugged into a 3 prong

outlet and grounded in accordance with all local codes and ordinances. If a 3 prong outlet is not available, it is the cus-

tomer's responsibility to have a properly grounded 3 prong outlet installed by a qualified electrician.

It is the customer's responsibility:

•

To contact a qualified electrician

•

To assure that the electrical installation is adequate

and in conformance with the National Electrical Code,

ANSI/NFPA 70 - latest edition, and all local codes and

ordinances.

LCDI Power Cord and Plug

This air conditioner is equipped with an LCDI (Leakage Current Detection and Interruption) power cord and plug as

required by US National Electric Code 440.65. This cord consists of a length of shielded flexible cord with no termination

on the load side and a LCDI attachment plug on the line side.

The LCDI power cord and plug will remove the supply source via electrical disconnect (circuit trip) if the nominal current

leakage between the cord shield and either load conductor exceeds a predetermined value. The cord will remain de-

energized until the devise has been manually reset. This is intended to reduce the risk of a fire in the power cord or

combustible materials nearby. The cord shields are not grounded and they must be considered a shock hazards if

exposed. The cord shield must not be connected to ground or to any exposed metal.

The test and reset buttons on the LCDI Plug are used to check if

the plug is functioning properly. To test the plug:

1. Plug power cord into a wall outlet

2. Press the TEST Button, the circuit should trip and cut all

power to the air conditioner

3. Press the RESET button for use

If a test is performed and the indicator light remains ON, the

current leakage has been detected. Do not use the air

conditioner or attempt to reset the LCDI Plug. Contact Customer

Service for troubleshooting recommendations.

The electrical ratings for your air conditioner are listed on the model and serial

number label located on the front left side of the unit (when facing the front).

Specific electrical requirements are listed in the chart below. Follow the

requirements below for the type of plug on the power supply cord.

Wiring Requirements

•

115 volt (103.5 min.—126.5

max)

•

0-12 amps

•

15-amp time-delay fuse or

circuit breaker

•

Use on single outlet circuit only

Copies of the standards listed may be obtained from:

Power Supply Cord

National Fire Protection Association

One Batterymarch Park

Quincy, Massachusetts 02269