AGT INDUSTRIAL AGT-WB24 Manuel du produit - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel du produit pour {nom_de_la_catégorie} AGT INDUSTRIAL AGT-WB24. AGT INDUSTRIAL AGT-WB24 18 pages.

conform to specified value. Check if there is any deformation on rim locating surface and mounting

hole. According to the wheel rim structure, select the appropriate tire installation method. Choose

the following two installation methods according to the wheel rim structure:

main shaft— (direction of the rim

installation surface is inside) —

suitable cone (small side inside) —quick nut

Note

when install or remove the wheel,it is not allowed to slide the wheel on main shaft screw,to

avoid any scratching.

2) turn on the power switch

3 ) input a b d value ( Automatic input gauge is optional function . No automatic gauge please enter

manually)

distance (a) value ：pull the scale to the position as in pic.1 and hold it for 4 seconds, read this value from

measuring scale, and input the value manually through

width (b) value ：read it directly from the rim or measure it by equipped caliper as in pic.2, and input the

value manually through

diameter (d) value ：read it directly from the rim, and input the value manually through

4) put down the hood or press

After the wheel stops, the digital tube displays unbalanced

weight.

6)Slowly rotate the tire counterclockwise by hand until the indicator light outer is all on. At this time, the highest

point (12 o 'clock) of the outer rim is the correct point of the unbalance. Add corresponding weight lead at this

position.

See Pic.3

Pic.1

key to rotate the wheel

main shaft—tower spring (big side inside)

-—wheel—quick nut

Pic.2

weight，press

key to read actual unbalance