Dean PRO250 Manuel d'utilisation - Page 3
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Dean PRO250. Dean PRO250 4 pages. 250 watt professional acoustic guitar amplifier
Imprimer la pagePRO-250 Rear Panel
DIRECT/LINE OUTPUTS: The PRO has both XLR (balanced) DIRECT OUT and 1/4" (unbalanced) LINE OUT outputs. The XLR
outputs can drive long cable lengths without added noise while the 1/4" outputs can drive virtually any line level input. Separate
CHANNEL-1, CHANNEL-2, and CHANNEL 1+2 outputs are post eq/efx to ensure a finished mixed signal to a PA system.
EFX LOOP - The PRO has 2 EFX Loops, one for Channel-1 and one for Channel-2
EFX SEND: This jack provides an unbalanced output signal from the preamp for supplying signals to external low-level effects or signal
processing equipment. This signal is "pre" tone controls. (The tone controls will not affect the EFX SEND signal)
EFX RETURN: Input for "returning" signals from external low-level effects or signal processing equipment. This signal is pre tone
controls and EFX. (Tone controls and on board digital EFX will affect this signal)
EFX F.S. (FOOTSWITCH): This jack is for connection to a shorting footswitch. When the switch is closed, the on board digital EFX for
the corresponding channel will be bypassed.
GROUND LIFT: This is a global ground lift, which lifts the ground from pin 1 of the XLR jacks and the sleeve of the 1/4" jacks to break
any ground loops between the PRO and a PA system.
PA IN: This input can be used in conjunction with another PRO amp. By providing a signal to this jack from the PRE OUT from another
PRO amp, you make this amp the slave amplifier. (The slave amplifier will be controlled by the amplifier providing the signal to the PA
IN jack.)
PRE OUT: This jack provides an unbalanced output from the preamp that is post eq and post efx. This send can be used to feed an
additional PRO amp to be used as a slave if more audio power is needed with your system.
AUX INPUT: Unbalanced stereo input jack. This is an auxiliary input designed for use with a drum machine, tape player, CD player,
etc. and can be used for playing prerecorded music.
AUX LEVEL: This "inset" control adjusts the volume level of the AUX input. This control can be adjusted with a small screwdriver. This
signal is pre MASTER control which means that the MASTER volume setting will affect the loudness of the TAPE/CD input signal.
AC INPUT: Connect the female end of the AC line cord here. Connect the male plug to a suitable source of line voltage. Refer to the
voltage information on the back of the amplifier for its voltage and current requirements. This connector also acts as the main fuse
holder and includes a compartment for a spare 5x20mm 6A fuse.
POWER: This rocker switch turns the AC power ON and Off. When ON the power indicator on the front panel is illuminated to indicate
the unit is ready for play.