Airfield 95A301 Instructions de montage - Page 2

Parcourez en ligne ou téléchargez le pdf Instructions de montage pour {nom_de_la_catégorie} Airfield 95A301. Airfield 95A301 3 pages.

Imprimer la page

Manual of Brushless Motor Speed Controller

Thanks for purchasing our Electronic Speed Controller (ESC). High power system for RC model is very dangerous, please read

this manual carefully. In that we have no control over the correct use, installation, application, or maintenance of our products,

no liability shall be assumed nor accepted for any damages, losses or costs resulting from the use of the product. Any claims

arising from the operating, failure or malfunctioning etc. will be denied. We assume no liability for personal injury, property

damage or consequential damages resulting from our product or our workmanship. As far as is legally permitted, the

obligation to compensation is limited to the invoice amount of the affected product.

（

Specifications:

Note: The Skywalker-6A,12A,12AE, 30A,60A and 80A are only used for RTF applications

Cont.

Model

Current

Skywalker-6A

Skywalker-12A

12A

Skywalker-12AE

12A

Skywalker-20A

20A

Skywalker-30A

30A

Skywalker-40A

40A

Skywalker-40A-UBEC

40A

Skywalker-60A-UBEC

60A

Skywalker-80A-UBEC

80A

Programmable Items:

Brake Setting：Enabled / Disabled

Battery Type：Lipo / NiMH

Low Voltage Protection Mode(Cut-Off Mode)： Soft Cut-Off (Gradually reduce the output power) /Cut-Off (Immediately stop the

output power)

Low Voltage Protection Threshold(Cut-Off Threshold)：Low / Medium / High

For lithium battery, the battery cell number is calculated automatically. Low / medium / high cutoff voltage for each cell is:

2.85V/3.15V/3.3V. For example: For a 3S Lipo, when "Medium" cutoff threshold is set, the cut-off voltage will be:

3.15*3=9.45V

For NiMH battery, low / medium / high cutoff voltages are 0%/50%/65% of the startup voltage (i.e. the initial voltage of

battery pack), and 0% means the low voltage cut-off function is disabled. For example: For a 6 cells NiMH battery, fully

charged voltage is 1.44*6=8.64V, when "Medium" cut-off threshold is set, the cut-off voltage will be: 8.64*50%=4.32V。

Startup Mode：Normal /Soft /Super-Soft (300ms / 1.5s / 3s)

Normal mode is suitable for fixed-wing aircraft. Soft or Super-soft modes are suitable for helicopters. The initial acceleration of the

Soft and Super-Soft modes are slower, it takes 1.5 second for Soft startup or 3 seconds for Super-Soft startup from initial throttle

advance to full throttle. If the throttle is completely closed (throttle stick moved to bottom position) and opened again (throttle stick

moved to top position) within 3 seconds after the first startup, the re-startup will be temporarily changed to normal mode to get rid of

the chance of a crash caused by slow throttle response. This special design is suitable for aerobatic flight when quick throttle

response is needed.

Timing：Low / Medium / High,( 3.75°/15°/26.25°)

Usually, low timing is suitable for most motors. To get higher speed, High timing value can be chosen.

Begin To Use Your New ESC

IMPORTANT! Because different transmitter has different throttle range, please calibrate throttle range before flying.

Throttle range setting: (Throttle range should be reset whenever a new transmitter is being used)

Switch on the

Connect battery

t r a n s m i t t e r,

pack

move throttle

ESC, and wait

stick to the

for

top position

seconds

Normal startup procedure:

Move throttle stick

Connect battery pack

to bottom position

to ESC, special tone

like "

and then switch

on transmitter.

power supply is OK

Protection Function

Start up failure protection: If the motor fails to start within 2 seconds of throttle application, the ESC will cut-off the output power. In

this case, the throttle stick MUST be moved to the bottom again to restart the motor. (Such a situation happens in the following

cases: The connection between ESC and motor is not reliable, the propeller or the motor is blocked, the gearbox is damaged, etc.)

Over-heat protection: When the temperature of the ESC is over about 110 Celsius degrees, the ESC will reduce the output power.

Throttle signal loss protection: The ESC will reduce the output power if throttle signal is lost for 1 second, further loss for 2 seconds

will cause the output to be cut-off completely.

Burst

BEC

Current

Mode

Output

(>10s)

Linear

5V/0.8A

15A

Linear

5V/1A

15A

Linear

5V/2A

25A

Linear

5V/2A

40A

Linear

5V/2A

55A

Linear

5V/3A

55A

Switch

5V/3A

80A

Switch

5V/5A

100A

Switch

5V/5A

(The option written in bold font is the default setting)

The "Beep-Beep-" tone

the

should

means the top point of

about

throttle range has been

confirmed

123" means

BEC Output Capability

2S Lipo

3S Lipo

4S Lipo

3 servos

3 servos 2 servos

5 servos 4 servos

5 servos 5 servos 5 servos

8 servos 8 servos 6 servos 6 servos

Move throttle stick to the

emitted,

bottom position, several

"beep-" tones should be

emitted to present the

amount of battery cells

Several "beep-" tones

should be emitted to

present the amount of

lithium battery cells

HW-SM003ENG-20120606

Battery Cell

6S Lipo

Lipo

NiMH

5-6 cells

2-3S

5-9 cells

2-3S

5-9 cells

2-3S

5-9 cells

2-3S

5-9 cells

2-3S

5-9 cells

2-4S

5-12 cells

2-6S

5-18 cells

2-6S

5-18 cells

A long "Beep-" tone should

emitted,

lowest

range has been correctly

confirmed

When self-test is

Move

finished,

long

upwards to go flying

"beep-----"

tone

should be emitted

Page 1 of 2

）

Size

Weight

L*W*H

5.5g

32*12*4.5

38*18*6

10g

38*18*7

19g

42*25*8

37g

68*25*8

39g

68*25*8

43g

65*25*12

63g

77*35*14

82g

86*38*12

means

the

point

throttle

stick