Adexa ZB10 Manuel d'instruction - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Adexa ZB10. Adexa ZB10 6 pages.

Imprimer la page

OPERATION PROCEDURES

1.Open the lid, take out the Ice-Storage-Basket and fill the drinkable

water into the water storage tank directly. Make sure that water level

is not over the bottom of the ice storage basket.

2.Connect power and press the start button on the operation board.

Ice maker will begin to work. Different ice sizes could be selected by

pressing the select button as per your requirement.

3. The ice making procedures are as follows:

1)Water is pumped into water box from water storage tank.

2)Ice making cycle begins, the evaporator dipped into the water

box starts to make ice;

3)It will take about 7 min ~ 15 min (according to customer's

requirement) for the ice making cycle, after it is finished,

water box will tilt forward and the remaining water will flow

back to the water storage tank.

4)Then water box will tilt backward and the ice pusher will push

the ice cubes into the ice storage basket. After the water box

turns back to the level position, the second ice making cycle begins.

4. The ice maker check the water volume in the Water-Storage-Tank

automatically. If the water volume is too low to make normal ice cubes,

it will stop working. When you add to appropriate water into the

Water-Storage-Tank, the indicator of water low will go out and it will

restart to work automatically.

5. When the ice cubes are collected to touch or near the ice sensor, the

ice maker will stop working and the indicator of ice full will light;

when you take out the ice cubes , the indicator of ice full will go

out and it will restart to work automatically.

6. If the indicators of ice full and water low glitter at the same time,

please turn off the machine , unplug the power cord and check whether

there are ice cubes blocked in the water box, if so,please take out the

cubes carefully; if no ice blocked, please turn the water box slightly

by hand, 3~5 minutes later, restart the machine. If there is no ice

blocking and also it is no use by turning the box slightly, the ice

maker may need repair. Please ask qualified technician to repair.

7. There are three sizes of the ice cubes available for customers'

selection. The bigger the ice cube is selected, the longer time is

needed to make it. When the ambient temperature is low (lower

than 15℃), the small or normal ice cubes are suggested to

choose to avoid the connection between the cubes.

8. Every time when taking out the ice cubes and reinstall the basket,

please push the basket downward to its original position to make

sure the temperature sensor is above the basket so as to ensure the

normal ice making cycle.

MAINTENANCE

1.To ensure the cleanliness of the ice cubes, water in the water storage

tank must be replaced every 24 hours.

2.The water strainer need to be cleaned regularly lest the impurities

in water come into the water pump to effect the normal operation

of machine.

3.If the compressor stops for any reasons such as lacking of water, too

much ice, power off, etc., Don't restart it right away. You should

restart it at least 3 minutes later to protect the compressor.

4.Screw off the drainage screw to drain the remaining water in the tank

when the ice maker will be unused for long time.

5.Please clean the ice maker regularly. When cleaning, disconnect

power and take out the ice cubes, use diluted cleaning agent to clean

the inside and outside surface of the maker. Water spraying for ice

maker is forbidden. Also the chemical diluted agents like acid agent,