BriskHeat ACR 3 MiniPRO Hot Bonder Manuel d'instruction - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} BriskHeat ACR 3 MiniPRO Hot Bonder. BriskHeat ACR 3 MiniPRO Hot Bonder 14 pages.

Imprimer la page

IMPORTANT SAFETY INSTRUCTIONS

A person who has not read
and understood all operating
instructions is not qualified to
operate this product.

Do not immerse or spray hot bonder with liquid.

Keep volatile or combustible material away from
hot bonder when in use.

Use hot bonder only in approved locations.

Keep sharp metal objects away from hot bonder.

The operator is not to open the enclosure. Only a
trained service person may open the enclosure.

Disconnect the power cord before opening the
enclosure. Turning off the power switch leaves
dangerous voltage levels accessible to the
service person.

If the equipment is used in a manner not specified
by the manufacturer, the protection provided by
the equipment can be impaired.
Failure to observe these warnings may result in
electric shock, risk of fire, and personal injury or
death.
End User Must Comply to the Following:

Only qualified personnel are allowed to connect electrical wiring.

All electrical wiring must follow local electrical codes and highly recommend following NEC
Article 427.

The end-user is responsible for providing a suitable disconnecting device.

The end-user is responsible for providing suitable electrical protection device. It is highly
recommended that a ground fault circuit breaker is used.

If a Protective Earth Conductor must be removed during service, it must be replaced.
Failure to observe these warnings may result in personal injury or damage to the product
and/or property.
®
© BriskHeat
Corporation. All rights reserved.
®
ACR
3 MiniPRO™ Hot Bonder

Inspect hot bonder before use.

Do not use hot bonder if damaged.

Do not repair damaged or faulty
hot bonders.

Do not position the equipment so
that it is difficult to operate the
disconnect device. The power cord
is the disconnect device.

Do not crush or apply severe
physical stress on hot bonder or
cord assembly.

Unplug hot bonder when not in use.

Only use power cords provided by
®
BriskHeat
Failure to observe these warnings may
result in personal injury or damage to
the product and/or property.
3

INTRODUCTION

®
®
TM
The BriskHeat
ACR
MiniPRO
Hot Bonder controls the heat and vacuum for
on-the-spot composite and metal bond repairs / cures. These systems are
portable and self-contained. For successful operation of this system, read and
understand these instructions prior to use.

PACKAGE CONTENTS

®
TM
● ACR
MiniPRO
Hot Bonder unit
● An accessory storage case containing:
- One 10ft (3m) input power cord with bare wire
- One 5ft (1.5m) heater output power cord
- 10 J-type thermocouples with mini connectors
- 10 Standard connector adapters for thermocouple receptacles
- One 10ft (3m) vacuum hose
- One vacuum bag feed-through
- One extra printer ribbon and roll of printer paper
- USB flash disk
®
TM
ACR
MiniPRO
Hot Bonder Kits with Heat Curing Blankets also include
various composite heat curing blankets. See www.briskheat.com for complete
details.
If any items are missing from the package, call your local distributor or
®
BriskHeat
at (800) 848-7673 (U.S. and Canada) or (614) 294-3376.
®
© BriskHeat
Corporation. All rights reserved.
®
ACR
3 MiniPRO™ Hot Bonder
4