Majestic RUBY35IN Instructions d'installation - Page 2

Parcourez en ligne ou téléchargez le pdf Instructions d'installation pour {nom_de_la_catégorie} Majestic RUBY35IN. Majestic RUBY35IN 3 pages. Direct vent gas fireplace inserts
Également pour Majestic RUBY35IN : Manuel de démarrage rapide (6 pages)

Imprimer la page

KIT COMPONENTS (Shown in Figure 1)

(1) Basepan Assembly

(1) Burner Assembly

(1) False Back

(1) Exhaust Baffle

(1) Bag Onyx Glass Media

(1) Bag Diamond Glass Media

(1) Bag 1/2 inch screws (25 screws per bag)

(1) Conversion Plate

(1) Stone Placement Jig

(1) Propane Orifice - .058", 1.55 mm

(1) NG Orifice - 38, 37

(2) Insulation Board (CKRUBY35 Only)

STONE

PLACEMENT

JIG

ROCK STOP

JIG

BURNER

ASSEMBLY

ADDITIONAL COMPONENT - 35 in. ONLY

INSULATION

BOARD

Figure 1. Contemporary Kit Metal Components

Majestic • CKRUBY30, CKRUBY35 Contemporary Kit Instructions • 2542-939 Rev. B • 2/19

EXHAUST

BAFFLE

FALSE BACK

PILOT

HOOD

BASE PAN

ASSEMBLY

Installation Instructions

1. Remove base refractory.

2. Remove the screws that attach the base pan to the

burner and lift the base pan out of the appliance.

3. Remove the burner bracket screw. Slide burner to the left

and lift out of the appliance. Be careful not to damage the

pilot sense rod.

4. Remove the exhaust baffle and replace with contem-

porary exhaust baffle. See Figure 2.

5. Remove the orifice using a 3/8 in. wrench and replace

with correct orifice for gas type. See BTU specification

table on page 1.

6. Adjust the air shutter and install contemporary burner

assembly. See BTU specification table on page 1.

7. Install contemporary base pan assembly.

Note: Install insulation board behind false back for

CKRUBY35 kit.

8. Install false back. See Figure 2.

EXHAUST BAFFLE

FALSE BACK SCREWS

Figure 2. Screw Location

9. If installing the glass refractory kit, refer to the installa-

tion instructions that came with the kit and install now.

10. If installing logs, refer to the instructions with the kit

and install now.

11. Install glass media. When using multiple media col-

ors, mix them prior to installation. For optimal per-

formance and flame appearance, ensure it is spread

evenly. See Figure 3.

Media Chart

Models

CKRUBY30 (NG)

CKRUBY30 (Propane)

CKRUBY35 (NG)

CKRUBY35 (Propane)

CAUTION

lace only one thin layer of media over the

burner and base pan when using Propane gas. Excess

media on burner and base pan may cause sooting. One

hin layer of media may require less media than indicated

in the above media chart.

SCREWS

Media

Quanity (Bag)

1-1/4

less than 1-1/4

1-1/2

less than 1-1/2