Bristan DSC 3HBF C Instructions d'installation et manuel d'utilisation - Page 10

Parcourez en ligne ou téléchargez le pdf Instructions d'installation et manuel d'utilisation pour {nom_de_la_catégorie} Bristan DSC 3HBF C. Bristan DSC 3HBF C 18 pages. Descent tap range
Également pour Bristan DSC 3HBF C : Manuel d'instructions d'installation (16 pages)

Imprimer la page

Installation Cont.

Wall Mounted Basin Mixer and

Bath Filler

1. Decide on the final position of the basin

mixer/bath filler. Install suitable batons into

the wall cavity if required to support the

tap body.

2. Plumb the hot and cold water supply

pipes to the required position.

3. Secure mixer body using the screws and

wall plugs supplied.

4. Attach the supply pipework to the hot

and cold inlets (hot on the left and cold on

the right when viewed from the front) en-

suring the olive is fitted to the copper pipe

work. Tighten the compression nut to secure

the pipework and create a water tight seal.

Note: Before finishing the wall surface turn

on both water supplies to check for any

leaking connections.

5. Finish the wall surface.

Note, it is important that a sufficient amount

of the spout connecting tube and valves are

left exposed to allow the spout and valve

shrouds to fit.

6. Fit the spout and tighten the grub screws

to secure in position.

7. Screw the valve shrouds onto the valves

using the screws supplied. Push the plinth

over the shroud.

8. Fit the spline adaptors to the valve splines

using the screws and washers supplied.

9. Push the handles onto the valve shrouds

and tighten the grub screws.

10. Turn on both water supplies and operate

the handle letting the water flow for a few

minutes to flush the system.

Need help? Give us a call on 0330 026 6273 and speak to one of our trained advisors.