Bristan Pisa PS2 BAS C Instructions d'installation et manuel de l'utilisateur
Parcourez en ligne ou téléchargez le pdf Instructions d'installation et manuel de l'utilisateur pour {nom_de_la_catégorie} Bristan Pisa PS2 BAS C. Bristan Pisa PS2 BAS C 2 pages.
Imprimer la page
Specifications
Cold Water Supply
Dynamic Water Pressure (Bar)
Min: 0.3
Max: 5.0
3.0
2.0
3.0
2.0
4.0
1.0
4.0
1.0
0
5.0
0
5.0
Pressure
Pressure
BAR
BAR
Min: 5°C Max: 25°C
Maximum Static Pressure: 10.0 bar
Tools You'll Need
Adjustable Spanner
Flexible Connecting pipes
Curved
Slight
90°
Kinks
round
bend
angle
Prior to Installation
All products manufactured and supplied by Bristan are
safe provided they are installed, used correctly and recieve
regular maintenance in accordance with these instructions.
This product has been tested to the Water Regulations
Advisory Scheme (WRAS) and satisfies the requirements
of the Water Supply (Water Fittings) Regulations 1999 and
current bylaws.
For full Installation Requirements & Notes (IRN) please
visit.
www.wras.co.uk/directory
Isolation valves must be fitted to the inlet water supplies to
ensure ease of future maintenane.
Before installing these taps the water supply must be
thoroughly flushed in order to remove any swarf, solder
etc from the pipework.
Installation Instructions
& User Guide
Please leave these instructions
with the end user
Product Code: PS2 BAS C
Inlet Water Temperature
Inlet Connections
Hot Water Supply
Max
65°C
80°C
25°C
60°C
5°C
60-65°C
80°C
Recommended
Maximum
Pipe Cutter
Hexagonal Keys
Flat Screwdriver
Pack Contents
Twists
x2
x1
Installation - Basin Mixer
1
(D2)
2
3
Flexible 1/2"
BSP
x1
Feed the flexi tails
through the hole in
the basin.
Installation- Clicker Waste
1
x1
x1
Fit the waste body and rubber
washer into the basin
2
1 2
4
2
Screw the flexi tails
into the
bottom of the mixer
body by hand only.
(DO NOT
Place the plinth over the hole
OVERTIGHTEN
)
in the basin ensuring that the
washer is fitted between the
1
4
Slide the
'C' shaped
rubber
washer
and the 'C'
shaped metal
washer onto
the fixing
rods up to
the underside
of the basin.
Secure the mixer in place
by tightening the fixing
nuts onto the fixing rod
against the 'C' shaped
metal washer.
2
Place shaped rubber washer
under the basin & secure
waste by tightening backnut
plinth and the basin.
5
Connect
the
flexible
5
tails to
the water
supplies.
system.
Operation-Clicker Waste
To fill the
basin, the
button needs
to be pressed
down
To release
water, press
the button
again