Bristan Quest QST BF C Instructions de montage et liste de contenu - Page 2
Parcourez en ligne ou téléchargez le pdf Instructions de montage et liste de contenu pour {nom_de_la_catégorie} Bristan Quest QST BF C. Bristan Quest QST BF C 2 pages. Bath filler
WATER PRESSURE
This mixer is suitable for use at all supply pressures. However for
optimum, both the hot and cold supplies should be reasonably
balanced.
If the fitting is installed at low pressure (tank fed), then the minimum
height from the outlet of the nozzle to the underside of the cold tank
should be 2 metres to ensure adequate performance.
This mixer should be installed in compliance with Water Regulations.
For further details contact your Local Water Authority.
CONTENTS
1. Mixer Body
(x1)
2. Back nut
(x2)
a. Valve
(x2)
b. Spline adaptor
(x2)
c. Screw
(x2)
d. Handle
(x2)
d
c
b
a
1
2
3
2
INSTALLATION
1. Identify all components and check for completeness, particularly
before arranging fitting.
2. Install the mixer body (1) to the bath using the back nuts (2)
provided.
3. Connect the hot and cold water supplies.
4. Turn on the water supplies. Turn on both hot and cold taps for a
few minutes letting the water flow, to check all joints and connections
for leaks.
5. See over the page for aftercare instructions.
MAINTENANCE
If the fitting begins to drip:
1. Turn off the water supply.
2. Remove handle (d) and then remove screw (c) by pulling from
valve (a).
3. Also remove spline adaptor (b) to avoid damaging it.
4. Using a suitable spanner, remove valve. Once removed, carefully
clean seating, rubber washer and ceramic disc.
5. Replace all of the above then turn on the water supply.
6. If problem persists contact our helpline quoting the product code.
PLEASE NOTE:
In the unlikely event you find a part missing please contact our
[email protected] for immediate dispatch of part.