AFPV SN-AAT Manuel - Page 5
Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} AFPV SN-AAT. AFPV SN-AAT 6 pages. Auto antenna tracker
Également pour AFPV SN-AAT : Manuel de l'utilisateur (6 pages)
Imprimer la page
SERVO AND BIAS
servo mode
1. Tracking：AAT real-time automatic control servo.
2. Offline：Keep the last moment;If the signal is lost or the AAT tilt angle is too
large,it will automatically enter offline mode.
*Please try to ensure that the device is stationary when powering up.
servo bais
1. bais1：Horizontal servo bais,1 degree at a time.
2. bais2：Vertical servo bais,1 degree at a time.
YWA/PITCH1/2
Accurately set the range of servo motion,avoid dead zones caused by a larger or smaller
range of motion angles than normal.
CALIBTATION
Compass calibration：
(1) Enter calibration:<KEY OPERATION>.
(2) Calibration step:vertical and horizontal for 3 turns.
(3) Verify calibration:enter the seting menu for angle calibration.If it is not accurate, there may
be magnetic field interference nearby,please check again.
(4)
Gyroscope：try to ensure that the device is stationary when powering up,AAT starts working after
gyroscope calibration is
Angle calibration:
(1) Enter calibration:
(2) Calibration step:
1st step:point north,pitch is 0 degrees.
1
2nd step:point east,pitch is 30 degrees.
2
3rd step:point south,pitch is 60 degrees.
3
4th step:point west,pitch is 90 degrees.
4
Calibration instructions:
If the compass is turned on during angle calibration, the above orientation refers to the geographical
orientation; otherwise, the front direction of the AAT is north.
INSTALLATION DIRECTION
FORWARD
BACKWARD
*After changing the installation direction, you need to restart AAT and recalibrate the compass!
completed.
<CAL>
.
Compass Closed
Screen pointing to south
Screen pointing to north
Compass Open
No need to care
No need to care