Bristan Club DUC DSM C Instructions de montage et liste de contenu - Page 2

Parcourez en ligne ou téléchargez le pdf Instructions de montage et liste de contenu pour {nom_de_la_catégorie} Bristan Club DUC DSM C. Bristan Club DUC DSM C 5 pages. Design utility kitchen ranges

Imprimer la page

Bristan Club DUC DSM C Instructions de montage et liste de contenu

Introduction

Thank you for choosing Bristan, the UK's leading taps and showers expert. We have designed this product with

your enjoyment in mind. To ensure that it works to its full potential, it needs to be fitted correctly. These fitting

instructions have been created to give you all of the information you need and, if you need any further help, please

do not hesitate to give us a call on 0844 701 6273.

Safety Note

Please read these instruction thoroughly and retain for future use.

All product manufactured and supplied by Bristan are safe provided they are installed correctly, used correctly and

receive regular maintenance in accordance with these instructions.

These fittings need to be installed in accordance with and meet the requirements of the Water Supply (Water

Fittings) Regulations 1999 and Scottish Byelaws 2004.

Water Pressure

These products are suitable for use at all supply pressures. If installed at low pressure (tank fed), then the

minimum distance from the outlet of the nozzle to the underside of the cold tank should be approximately 2 metres

to ensure adequate performance. The taps should be installed in compliance with Water Regulations. For further

details contact your Local Water Authority.

Installation – – – – High Neck Taps

Installation

High Neck Taps

Installation

High Neck Taps

1. Identify all components and check for completeness, particularly before arranging fitting.

2. Install the taps (3) to the basin/sink. The backnut (1) and backnut washer (2) are used

under the basin/sink to secure the tap to the surface of basin/sink.

3. Connect the hot and cold water supplies to the taps.

4. Turn on the water supplies. Open both taps letting the water flow for a few minutes to

check all joints and connections for leaks.

Contents

1. Backnut

2. Backnut Washer

3. Body

4. Valve

5. Handle

6. Handle Screw

7. Indices

Deck Sink Mixer

1. Identify all components and check for completeness, particularly before arranging fitting.

2. Attach the spout into the body (3), secure in place with the grub screw ensuring the spout is able to rotate freely.

3. Fit the mixer to the sink using the backnut washers (2) and backnuts (1)below the surface. Then connect the hot

and cold water supplies to the mixer.

4. Fully open both valves, letting the water run for a few minutes to check all connections for leaks.