AIRFLO ZB-250 Manuel d'instruction - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} AIRFLO ZB-250. AIRFLO ZB-250 9 pages.

Imprimer la page

next cycles will count down from 11 minutes. If you press twice, then the countdown will be from

12 minutes and so on.

Step 6 Auto clean function: before the unit is switched on, press the TIMER/CLEAN button for 3

seconds until it reflects the auto clean mode.

Step 7 Press ON/OFF button again to switch the unit off.

Care and Maintenance

1. Clean the inner liner, water box, ice shovel and evaporator frequently. When cleaning, unplug

the unit and remove the ice cubes. Use a diluted solution of water and vinegar to clean the

inside and the outside surface of the Ice Maker. Do not spray Ice Maker with chemicals or

diluted agents such as acids, gasoline or oil. Rinse thoroughly before starting.

Keep ventilation openings clear of obstruction. Do not use mechanical devices or other

means to accelerate the defrosting process, other than those recommended by the

manufacturer.

3. To ensure the cleanliness of the ice cubes, water in the water reservoir should be replaced

every 24 hours.

4. If the compressor stops for any reason such as water shortage, too much ice, power off, etc.,

do not start the system right away. Wait 3 minutes and then re-start the Ice Maker.

5. Always fill up with fresh water.

Troubleshooting

Problem

The compressor works

abnormally

with

buzzing noise

The "ADD WATER" light

is on

Indicator light on the

display is not on

The water is flowing, ice

is made, however no

release of ice

Everything is correct but

no ice is made.

Possible Cause

The voltage is lower

than recommended

There is no water or

water is not enough

1.Control panel wire

line is loosened

2.Control panel is

broken

Temperature sensors

are connected by

mistake

1.Refrigerant leaks

2.Cooling system

blocked