BRISTERS Chuck Wagon Soft Cab Enclosure Manuel de démarrage rapide

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} BRISTERS Chuck Wagon Soft Cab Enclosure. BRISTERS Chuck Wagon Soft Cab Enclosure 2 pages.

Imprimer la page

Notes:

• Requires Brister's folding windshield accessory (not included).

• Soft cab can be used with or without ABS hard top.

• Holes must be punched in soft cab to use hard top.

• Doors will close on outside of hard top or the hard top can be trimmed to clear the

doors. (Brister's recommends closing the doors on the outside of the top.)

Fastener package includes:

4-clamps

4-hinge clamps

*** Remove ABS Hard top and windshield before installation***

1. Install clamps around middle of the upper rear bends of

cage, secure back bar (A) to clamps with 7/16 nuts and

bolts.

2. Assemble door by inserting middle bar (D) into one side

of door and tap with rubber mallet. To match up door

halves, the hinge pin should be on the outside of the rear

half while the long latch handle is on the inside of the front

half. Insert crimped ends into opposite side of door and tap

together. Repeat for second door.

3. Install door hinge clamps on rear cage bar next to top of seat and below bottom of seat.

Secure with 7/16 nuts & bolts. Insert hinge pin into hinge clamp (long handle will be on

inside of door.)

Chuck Wagon Soft Cab

8-7/16 nuts & bolts

A-back Bar

Enclosure

left and right doors

2-D bars